M.A. Ford
M.A. Ford Twister XD 3X Solid Carbide Drill 3.90 mm 2XDSS1535A
3X solid carbide drill creates precise 3.90 mm holes in tough materials
- Twister XD design enables 3X faster drilling in tough materials
- 90 mm diameter matches precise hole-size requirements
- Solid carbide construction resists wear for extended tool life
- 2XDSS1535A geometry optimises chip evacuation during deep cuts
- California Proposition 65 warning ensures informed workplace safety
Twister XD 3X 3.90 mm carbide drill
The M.A. Ford Twister XD 3X is a solid carbide drill with a 3.90 mm cutting diameter. It is designed for machinists and maintenance teams who need a rigid, wear-resistant tool for producing accurate holes in ferrous and non-ferrous alloys.
California Proposition 65 chemical notice
This product contains a chemical known to the State of California to cause cancer and birth defects or other reproductive harm. Users should follow standard workshop hygiene, use appropriate personal protective equipment and ensure adequate ventilation during drilling operations.
Solid carbide construction and shank fit
The one-piece carbide body provides high stiffness and heat resistance for consistent performance in CNC and manual drilling. The cylindrical shank fits standard 3.90 mm collets and drill chucks, allowing quick tool changes without specialised holders.
Highlights
- Twister XD design enables 3X faster drilling in tough materials
- 90 mm diameter matches precise hole-size requirements
- Solid carbide construction resists wear for extended tool life
- 2XDSS1535A geometry optimises chip evacuation during deep cuts
- California Proposition 65 warning ensures informed workplace safety
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How do you install the 3.90 mm Twister XD drill bit in a drill chuck, and what step causes run-out?
Open the chuck fully, insert the shank until it seats on the 3.90 mm flute transition, then tighten evenly; the common error is stopping short of the transition, which leaves a gap and creates run-out.
What maintenance or replacement will the solid carbide 2XDSS1535A drill need after extended use?
The cutting edges dull first; resharpen on a diamond wheel using the original 1535 point geometry, or replace the bit once the margin wear reaches the flute land.
Which limit appears first when drilling continuously with the 3X Twister XD carbide drill?
Heat buildup at the 3.90 mm tip reaches the carbide's thermal limit before flank wear becomes critical, so coolant flow or peck cycles must control temperature.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
