M.A. Ford
M.A. Ford Twister Xd 3X Solid Carbide Drill 3.30 mm
Solid carbide drill bit creates precise 3.30 mm holes in tough materials
- 30 mm diameter suits precise drilling tasks
- Solid carbide construction resists wear and heat
- Twister Xd 3X geometry improves chip evacuation
- M.A. Ford brand signals professional-grade tooling
- California Proposition 65 warning included for compliance
Drill diameter 3.30 mm
The M.A. Ford Twister Xd 3X is a solid carbide drill designed for power tool applications. Its 3.30 mm cutting diameter suits precision drilling tasks in professional workshops. The tool carries the manufacturer part reference 2XDSS1299A and is supplied new. A California Proposition 65 notice applies because the product contains a listed chemical.
Machinists needing a single-size carbide drill
This drill suits machinists and maintenance teams that require a dedicated 3.30 mm solid carbide tool for repeated use. It is not for operators who need a set covering multiple diameters or who prefer indexable-insert drills for lower per-hole cost. Buyers avoiding Proposition 65 listed substances should also consider alternatives.
3.30 mm cutting diameter decides fit
The 3.30 mm diameter is the critical specification that determines whether this drill matches the required hole size. Verify the target hole tolerance and material compatibility before purchase. The solid carbide construction supports rigid setups but the single diameter means a different tool is needed for any other size.
Highlights
- 30 mm diameter suits precise drilling tasks
- Solid carbide construction resists wear and heat
- Twister Xd 3X geometry improves chip evacuation
- M.A. Ford brand signals professional-grade tooling
- California Proposition 65 warning included for compliance
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How do I install the 3.30 mm Twister Xd drill in my drill chuck and what step is often missed?
Clamp the cylindrical shank fully into a clean, matched collet or three-jaw chuck, then verify run-out before starting; the step most often missed is checking concentricity after tightening.
What maintenance will the 2XDSS1299A solid carbide drill need later?
Inspect cutting edges for flank wear or chipping after each job; when dull, send the drill to a specialist carbide grinding service for reconditioning.
What limit appears first on the Twister Xd 3X drill during sustained high-speed drilling?
Heat build-up at the cutting zone is the first limit; without through-coolant the solid carbide body reaches critical temperature faster than coated HSS drills.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
