M.A. Ford
M.A. Ford Twister Xd 3X Solid Carbide Drill 3.10mm 2XDSS1220A
Solid carbide drill creates precise 3.10mm holes in demanding materials
- 10 mm diameter drills precise holes in metal
- Solid carbide construction resists wear for longer life
- Twister Xd 3X geometry improves chip evacuation
- M.A. Ford quality trusted by professionals
- California Prop 65 warning applies to this item
3.10 mm solid carbide drill
The M.A. Ford Twister Xd 3X is a solid carbide drill with a 3.10 mm cutting diameter. It is built for machinists and maintenance teams who need a rigid, wear-resistant tool for short-hole drilling in steel and cast iron. The 3X length ratio keeps deflection low in handheld and CNC applications.
Replaces general-purpose HSS and cobalt drills
Switching from high-speed steel or cobalt bits is worth it when hole count, tolerance or tool life become the bottleneck. Carbide holds its edge longer at higher speeds, so the jump pays off in repetitive production runs where frequent resharpening or bit changes slow the cycle.
Limited by carbide brittleness and 3X flute length
The material chips if the workpiece moves or the spindle runs out of true, so rigid clamping and a stable machine are essential. The 3X flute depth restricts the maximum hole depth to roughly three times the diameter, and the lack of internal coolant channels means external flood or mist is required for deeper cuts.
Highlights
- 10 mm diameter drills precise holes in metal
- Solid carbide construction resists wear for longer life
- Twister Xd 3X geometry improves chip evacuation
- M.A. Ford quality trusted by professionals
- California Prop 65 warning applies to this item
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What chuck size fits the 3.10 mm shank on this Twister Xd drill?
Use a 3.10 mm or 1/8 inch drill chuck; the solid carbide shank is ground to 3.10 mm so it seats without a reducer sleeve.
How do you install the 2XDSS1220A bit without snapping the carbide?
Clamp the workpiece, start the spindle at low RPM, feed gently until the tip centres, then increase to recommended speed — never hammer or side-load the flute.
When should the 3.10 mm Twister Xd be replaced?
Replace when the cutting lips show visible wear, the drill walks on entry, or hole diameter exceeds tolerance; solid carbide cannot be economically resharpened.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
