M.A. Ford
M.A. Ford Twister Xd 3X Solid Carbide Drill 2570 F
Solid carbide drill bit designed for high-performance drilling applications
- Solid carbide construction resists wear
- Twister Xd geometry improves chip evacuation
- 3X diameter capability reaches deeper holes
- Size 2570 fits precise drilling tasks
- New condition ensures full tool life
Twister Xd 3X Solid Carbide Drill
The M.A. Ford Twister Xd 3X is a solid carbide drill designed for precision holemaking in demanding materials. It targets machinists and maintenance technicians who need reliable performance in production or repair environments. The F designation indicates a specific diameter for exacting applications.
Upgrade from standard high-speed steel
Replacing general-purpose high-speed steel drills with this carbide tool extends tool life and maintains tighter tolerances in abrasive or hardened workpieces. The jump is justified when cycle time reduction and consistent hole quality outweigh the higher initial cost per unit.
Sustained cutting in abrasive alloys
Solid carbide construction resists wear and deflection during continuous drilling operations better than cobalt or coated steel alternatives. It holds centre accuracy and surface finish through extended production runs without frequent resharpening or tool changes.
Highlights
- Solid carbide construction resists wear
- Twister Xd geometry improves chip evacuation
- 3X diameter capability reaches deeper holes
- Size 2570 fits precise drilling tasks
- New condition ensures full tool life
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank diameter does the 2570 F drill need to fit my drill chuck?
The drill is a solid-carbide Twister Xd 3X with an F-letter size; match the chuck capacity to that diameter for a secure grip.
How do I install the 2570 F bit without snapping the carbide?
Clamp the workpiece rigidly, use a centre punch mark, start at low RPM with steady feed, and avoid side loads that crack the solid-carbide body.
When should I replace the 2570 F drill?
Replace it when the cutting lips show chipping, the margin wear reaches the flute, or hole size drifts beyond tolerance — solid carbide cannot be economically resharpened.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
