M.A. Ford
M.A. Ford Twister XD 3X Solid Carbide Drill 18.00mm 2XDSS7087A
An 18.00 mm solid-carbide drill for high-performance drilling applications
- Solid carbide construction resists wear
- Twister XD geometry improves chip evacuation
- 3X diameter capability enables deeper holes
- 00 mm diameter suits precise drilling tasks
- California Proposition 65 warning informs safe handling
Twister XD 3X 18.00 mm Carbide Drill
This solid carbide drill is built for high-precision holemaking in demanding materials. The Twister XD 3X geometry reduces thrust and improves chip evacuation. It suits machinists and maintenance teams who need consistent performance in production or repair work.
18.00 mm cutting diameter
The drill cuts a precise 18.00 mm diameter, which is the single dimension that determines fit for your application. Verify the required hole size and material compatibility before ordering. No other diameter or shank option is offered for this part number.
For machinists drilling 18.00 mm holes in tough
Buyers who need a different diameter, a stepped drill, or a coolant-through design should look at other tooling. This item is not suited for hand-held drilling without rigid setup or for materials outside the Twister XD range.
Highlights
- Solid carbide construction resists wear
- Twister XD geometry improves chip evacuation
- 3X diameter capability enables deeper holes
- 00 mm diameter suits precise drilling tasks
- California Proposition 65 warning informs safe handling
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What does the 18.00 mm diameter mean when drilling in a real machine?
The 18.00 mm diameter is the exact cutting width; the drill will produce a hole of that size in one pass without needing a pilot hole.
What shank standard does the 2XDSS7087A use and what does it limit?
It uses a standard solid-carbide shank that fits common drill chucks and collets, limiting use to holders that accept the same shank diameter.
What physical clearance does the 18.00 mm drill need to fit in a tool holder?
The holder must accept an 18.00 mm shank and provide enough axial length for the 3X flute section plus the shank.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
