M.A. Ford
M.A. Ford Twister Xd 3X Solid Carbide Drill 10.10mm
Solid carbide drill bit for high-performance drilling at 10.10 mm diameter
- Solid carbide construction delivers long tool life
- 3X diameter design enables deeper holes in one pass
- 10 mm diameter suits precise drilling tasks
- Twister Xd geometry improves chip evacuation
- M.A. Ford brand trusted for professional performance
Application focus
This M.A. Ford Twister Xd 3X solid carbide drill is built for precision drilling in tough materials. The 10.10 mm diameter suits metalworking shops and maintenance teams that need accurate holes without frequent tool changes. It targets users who value rigidity and long edge life in a single-pass operation.
Sustained performance
The solid carbide construction resists deflection and heat buildup during continuous cutting cycles. The Twister Xd geometry promotes stable chip evacuation, which helps maintain hole quality when drilling deeper than a typical stub-length bit allows. Consistent feed rates remain achievable without the wander common in thinner web designs.
Upgrade context
This drill replaces general-purpose high-speed steel or economy carbide bits that dull quickly in abrasive alloys. The step up is justified when hole tolerance and tool life outweigh the higher upfront cost. Shops drilling only occasional soft materials will not see the return on investment.
Highlights
- Solid carbide construction delivers long tool life
- 3X diameter design enables deeper holes in one pass
- 10 mm diameter suits precise drilling tasks
- Twister Xd geometry improves chip evacuation
- M.A. Ford brand trusted for professional performance
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How much heat does the 10.10 mm Twister Xd drill generate during continuous drilling?
The solid carbide construction dissipates heat efficiently, reducing thermal buildup in the workpiece and extending tool life during prolonged use.
What tool holder or chuck is required to run the 10.10 mm Twister Xd drill?
A standard drill chuck or collet that accepts a 10.10 mm shank will secure this drill for use in a drill press or handheld drill.
Will the 10.10 mm Twister Xd drill fit in my older drill press with a 1/2 inch chuck capacity?
The 10.10 mm diameter is slightly under 1/2 inch, so it fits within a 1/2 inch chuck, but verify your chuck's minimum clamping size.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
