M.A. Ford
M.A. Ford Twister XD 3X Coolant Fed Drill 9.10 mm 2XDCS3583A
A 9.10 mm coolant-fed drill designed for high-performance drilling applications
- Coolant-fed design clears chips efficiently during deep drilling
- 3X diameter capacity enables deeper holes in a single pass
- 10 mm diameter suits precise metric hole requirements
- M.A. Ford manufacturing delivers reliable cutting performance
- California Proposition 65 warning informs safe handling practices
Twister XD 3X Coolant-Fed Drill
The M.A. Ford Twister XD 3X is a coolant-fed drill designed for precision holemaking in demanding materials. Its through-tool coolant delivery improves chip evacuation and extends tool life during deep drilling cycles. This 9.10 mm diameter tool targets machinists and production shops requiring consistent performance in high-temperature alloys or stainless steels.
Upgrade from Standard Twist Drills
Conventional twist drills without internal coolant often overheat and wander at depth, leading to oversize holes or premature failure. The 3X length and coolant-fed design eliminate the need for peck drilling in many applications, reducing cycle time. The jump is justified when hole straightness, surface finish, and unattended operation become critical requirements.
9.10 mm Diameter with 3X Reach
The 9.10 mm cutting diameter suits common fastener and dowel pin clearances in metric designs. The 3X diameter-to-length ratio provides sufficient reach for through-holes in thick flanges or stacked plates without deflection. It runs out when hole depths exceed three times the diameter or when machine spindle coolant pressure falls below the threshold needed for effective through-tool flow.
Highlights
- Coolant-fed design clears chips efficiently during deep drilling
- 3X diameter capacity enables deeper holes in a single pass
- 10 mm diameter suits precise metric hole requirements
- M.A. Ford manufacturing delivers reliable cutting performance
- California Proposition 65 warning informs safe handling practices
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank size does the 9.10 mm Twister XD drill need to fit my drill chuck?
The drill has a 9.10 mm cutting diameter; match it to a chuck that accepts at least 9.10 mm shank.
How do I install the 2XDCS3583A coolant-fed drill so coolant reaches the tip?
Mount the drill in a holder with through-coolant passages, connect the coolant supply, and verify flow exits at the drill point before cutting.
When should I replace the Twister XD 3X drill?
Replace it when the 9.10 mm cutting edges show wear, chipping, or when hole quality and coolant flow degrade.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
