M.A. Ford
M.A. Ford Twister Xd 3X Coolant Fed Drill 7.50 mm 2XDCS2953A
Coolant-fed drill creates 7.50 mm holes with three-times diameter depth capability
- Coolant-fed design clears chips efficiently
- 50 mm diameter drills precise holes
- 3X length reaches deeper cavities
- Twister Xd geometry improves cutting performance
- M.A. Ford quality ensures reliable operation
Twister Xd 3X coolant drill
The M.A. Ford Twister Xd is a coolant-fed drill bit designed for production drilling where through-tool lubrication improves chip evacuation and tool life. It suits machine shops and maintenance teams that run dedicated coolant systems on CNC mills or lathes. The 3X length provides extended reach for deeper holes without changing set-ups.
7.50 mm diameter and 3X reach
A 7.50 mm cutting diameter matches standard metric tap sizes and fits common collets or drill holders without adapters. Coolant exits at the tip through internal channels so fluid reaches the cutting zone directly, reducing heat build-up and helping to break chips in ductile materials. The straight shank mounts in hydraulic, shrink-fit or ER collet chucks for rigid clamping.
Proposition 65 chemical notice
California Proposition 65 warnings indicate the product contains substances identified by the state as causing cancer and reproductive harm. Shops must follow local safety-data-sheet requirements, provide appropriate personal protective equipment and ensure ventilation or extraction when machining. No performance specifications beyond diameter and length are supplied so cutting parameters should be verified against the manufacturer’s technical data.
Highlights
- Coolant-fed design clears chips efficiently
- 50 mm diameter drills precise holes
- 3X length reaches deeper cavities
- Twister Xd geometry improves cutting performance
- M.A. Ford quality ensures reliable operation
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank interface does the Twister Xd 3X coolant-fed drill use, and what diameter does that cap the tool at?
The drill uses a standard straight shank that fits 7.50 mm holders, limiting the cutting diameter to 7.50 mm.
What machine spindle and holder dimensions are required to mount this 7.50 mm drill?
A 7.50 mm collet or drill chuck with through-coolant capability is required for secure mounting.
How is the Twister Xd 3X installed, and which step is often missed?
Insert the shank fully into the coolant-fed holder, tighten the collet nut to torque, then verify coolant flows through the drill before starting the cycle.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
