M.A. Ford
M.A. Ford Twister Xd 3X Coolant Fed Drill 3.10mm 2XDCS1220A
A 3.10 mm coolant-fed drill delivers three-times-diameter depth in one pass
- Coolant-fed design clears chips during deep drilling
- 3X diameter reach handles deeper holes in one pass
- 10 mm diameter suits precise pilot holes
- M.A. Ford manufacturing backs consistent performance
- California Proposition 65 warning informs safe handling
Application focus
The M.A. Ford Twister Xd 3X is a coolant-fed drill built for precision holemaking in demanding materials. It targets machinists and maintenance teams who need consistent chip evacuation and tool life when drilling deep or difficult bores. The 3.10 mm diameter suits fine-detail work in aerospace, medical or general engineering shops.
Capacity and headroom
The 3X length-to-diameter ratio provides extended reach for holes up to approximately three times the drill diameter. Internal coolant delivery flushes chips from the cutting zone, maintaining accuracy and surface finish where external flood coolant cannot reach. The design handles tough alloys and deep-hole cycles that would stall a standard twist drill.
Interface limits
The shank fits standard toolholders and collets sized for this diameter range, allowing use on CNC machining centres, lathes or rigid drill presses with through-spindle coolant capability. Without a compatible coolant-through spindle or induced coolant system the internal channels cannot function, so the drill reverts to external cooling only. California Proposition 65 warnings apply to chemicals present in the tool materials.
Highlights
- Coolant-fed design clears chips during deep drilling
- 3X diameter reach handles deeper holes in one pass
- 10 mm diameter suits precise pilot holes
- M.A. Ford manufacturing backs consistent performance
- California Proposition 65 warning informs safe handling
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Will the 3.10 mm shank fit the collet I already use on my CNC spindle?
The drill has a 3.10 mm diameter shank, so it will fit any standard ER collet or hydraulic holder sized for 3.10 mm tooling.
How can I confirm coolant is reaching the cutting edges after I install the drill?
Run the machine at low speed with coolant on and watch for a steady stream exiting the two through-tool holes at the tip; consistent flow means the internal passages are clear.
Does the package include the 2XDCS1220A drill only, or are collets and coolant adapters supplied?
Only the Twister Xd 3X coolant-fed drill is included; collets, pull studs and any machine-specific coolant adapters must be purchased separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
