M.A. Ford
M.A. Ford Twister Micro-Tuff Drill No 96 30500630
Precision micro-drill No 96 for accurate small-hole drilling in various materials
- Precision drilling with Twister Micro-Tuff design
- Model No 96 for consistent performance
- M.A. Ford quality for reliable results
- Part number 30500630 ensures exact identification
- California Prop 65 chemical warning applies
Twister Micro-Tuff Drill No 96
This drill bit belongs to the Twister Micro-Tuff range from M.A. Ford and carries the manufacturer part number 30500630. It is intended for precision drilling tasks where a small-diameter, high-performance cutting tool is required. The product is supplied new and ships directly from the manufacturer.
Sustained cutting performance
The Micro-Tuff construction is designed to maintain edge integrity and resist wear during extended drilling cycles rather than only in short bursts. This helps deliver consistent hole quality and tool life when the drill is used continuously in demanding materials. The geometry supports stable chip evacuation over long runs.
California Proposition 65 notice
This product contains a chemical known to the State of California to cause cancer and birth defects or other reproductive harm. Buyers who require components without such substances should select an alternative drill bit. The warning applies to the item as supplied by M.A. Ford.
Highlights
- Precision drilling with Twister Micro-Tuff design
- Model No 96 for consistent performance
- M.A. Ford quality for reliable results
- Part number 30500630 ensures exact identification
- California Prop 65 chemical warning applies
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Does the M.A. Ford Twister Micro-Tuff Drill No 96 generate noticeable heat or noise during extended drilling sessions?
The drill is a solid carbide cutting tool with no motor or electronics, so it produces no operational noise or heat of its own; any sound or warmth comes from the machine spindle and workpiece interface.
What shank size or tool holder must I already have to run the 30500630 drill in my machine?
The drill uses a standard straight shank sized to its nominal diameter; you need a collet, chuck or shrink-fit holder that matches that shank diameter for secure clamping.
Can the No 96 Micro-Tuff drill be used on older manual milling machines or only on modern CNC centres?
It performs well on any rigid spindle that can maintain the recommended speed and feed; older manual machines work if they provide sufficient run-out control and coolant delivery.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
