M.A. Ford
M.A. Ford Twister Micro-Tuff Drill 305M0036 0.36mm pneumatic accessory
Twister Micro-Tuff drill bit drills 0.36 mm holes in precision applications
- Precision drilling with 0.36 mm micro-diameter
- Twister Micro-Tuff geometry for tight-tolerance holes
- M.A. Ford manufacturing for professional tool reliability
- California Prop 65 chemical-hazard disclosure included
- Brand-new condition ready for immediate workshop use
M.A. Ford Twister Micro-Tuff Drill 0.36mm
The M.A. Ford Twister Micro-Tuff Drill 305M0036 is a precision pneumatic accessory with a 0.36mm diameter. It is designed for detailed drilling tasks in professional workshop environments. The item is supplied new and ships directly from the manufacturer.
Suited for fine-detail drilling applications
This drill suits technicians who require a very small cutting diameter for intricate work. It is not suitable for buyers who need larger hole sizes or higher material removal rates. The product carries a California Proposition 65 warning for chemicals known to cause cancer and reproductive harm.
0.36mm cutting diameter defines the application
The 0.36mm diameter is the critical specification determining if this tool matches the required hole size. Verify this measurement against your engineering drawings before purchase. Orders of $75 or more qualify for free shipping from the manufacturer.
Highlights
- Precision drilling with 0.36 mm micro-diameter
- Twister Micro-Tuff geometry for tight-tolerance holes
- M.A. Ford manufacturing for professional tool reliability
- California Prop 65 chemical-hazard disclosure included
- Brand-new condition ready for immediate workshop use
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Does the 0.36 mm drill generate noticeable heat or vibration during extended pneumatic use?
The Micro-Tuff design is engineered for micro-hole precision, so heat build-up stays low even when the tool runs continuously on a pneumatic line.
What pneumatic fittings or air supply must I already have to run the 305M0036?
You need a standard pneumatic quick-connect fitting and a regulated air supply capable of delivering the pressure range the drill is rated for.
Will the 0.36 mm bit work in my older drill press or only in a dedicated pneumatic spindle?
The shank matches common micro-drill collets, so it fits both modern pneumatic spindles and legacy drill-press chucks that accept 0.36 mm tooling.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
