M.A. Ford
M.A. Ford Twister Micro-Tuff Drill 1.95 mm
Drills precise 1.95 mm holes in tough materials using Micro-Tuff geometry
- Precision drilling at 1.95 mm diameter
- Micro-Tuff coating extends tool life
- Twister flute design improves chip evacuation
- M.A. Ford 305 series quality construction
- California Prop 65 chemical disclosure included
Precision Micro Drill
The M.A. Ford Twister Micro-Tuff Drill has a 1.95 mm cutting diameter for fine hole-making in metal and composite materials. It is intended for machinists and technicians who need repeatable accuracy in small-diameter work.
Sustained Cutting Behaviour
The Micro-Tuff geometry resists premature wear when the drill is run at consistent feed rates through abrasive alloys. Heat buildup remains manageable during extended cycles, reducing the risk of work hardening at the hole wall.
Shank and Holder Limits
The straight shank fits standard collets and drill chucks that accept 1.95 mm tooling. Runout must be kept minimal because the small diameter amplifies any eccentricity, and the tool is not suited for deep holes beyond the flute length.
Highlights
- Precision drilling at 1.95 mm diameter
- Micro-Tuff coating extends tool life
- Twister flute design improves chip evacuation
- M.A. Ford 305 series quality construction
- California Prop 65 chemical disclosure included
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Does the 1.95 mm Twister Micro-Tuff drill generate noticeable heat or vibration during extended drilling in steel?
The drill is designed for micro drilling; heat and vibration depend on spindle speed, feed rate and coolant use rather than on the tool alone.
What shank size and tool holder does the 1.95 mm Twister Micro-Tuff drill require to run correctly?
The drill has a 1.95 mm diameter; the shank matches that diameter so a collet or chuck that grips 1.95 mm round shanks is needed.
Will the 1.95 mm Twister Micro-Tuff drill fit the spindle and collets of an older micro drill press?
It fits any press that accepts a 1.95 mm shank; check the machine’s minimum collet capacity and run-out before use.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
