M.A. Ford
M.A. Ford Twister Micro-Tuff Drill 1.75 mm
A 1.75 mm Twister Micro-Tuff drill bit built for precision drilling in tough materials
- Precision drilling with 1.75 mm diameter
- Twister Micro-Tuff design for clean holes
- M.A. Ford industrial-grade manufacturing quality
- Ships direct from manufacturer for authenticity
- California Prop 65 chemical warning applies
Micro-Tuff Drill 1.75 mm
The M.A. Ford Twister Micro-Tuff Drill is a 1.75 mm cutting tool designed for precision drilling tasks. It is supplied new and targets machinists and technicians who require small-diameter holes in a variety of materials.
Suited for fine detail work
This drill suits operators producing small, accurate holes where a 1.75 mm diameter is specified. It is not intended for buyers who need larger diameters, higher material removal rates, or shank sizes that differ from the standard Micro-Tuff range.
Capacity limited to 1.75 mm
The tool comfortably handles its nominal 1.75 mm diameter in appropriate workpiece materials. It reaches its limit when hole sizes exceed this value or when applications demand coolant-through capability or specialised coatings not indicated for this model.
Highlights
- Precision drilling with 1.75 mm diameter
- Twister Micro-Tuff design for clean holes
- M.A. Ford industrial-grade manufacturing quality
- Ships direct from manufacturer for authenticity
- California Prop 65 chemical warning applies
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What chuck size do I need to hold the 1.75 mm shank?
A drill chuck that closes down to 1.75 mm or smaller will grip the shank; check your chuck's minimum capacity before use.
Can I run this drill in a standard 3/8 in cordless drill?
Yes, if the chuck can tighten fully on a 1.75 mm shank; many 3/8 in keyless chucks stop at a larger minimum, so verify the spec.
How do I confirm the bit is cutting correctly after I start drilling?
The drill should produce a steady, quiet cut with consistent chip formation and no wobble; vibration or squealing means the shank is not seated or the speed is wrong.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
