M.A. Ford
M.A. Ford Twister Micro-Tuff Drill 1.05mm pneumatic accessory
A 1.05 mm Twister Micro-Tuff drill bit, model 305M0105AM, for precision pneumatic drilling tasks
- Precision drilling with 1.05 mm diameter
- Micro-Tuff construction for extended tool life
- Twister flute design improves chip evacuation
- M.A. Ford quality for professional results
- California Prop 65 chemical warning applies
Micro drill for precision work
The M.A. Ford Twister Micro-Tuff Drill has a 1.05 mm cutting diameter for fine hole-making in metals and composites. It suits technicians and hobbyists who need repeatable accuracy in small-scale assembly or repair tasks. The solid-carbide construction resists wear during repeated use.
Capacity and headroom at 1.05 mm
This diameter handles pilot holes for small fasteners, wire routing and delicate component mounting. It runs out when the application demands larger clearance holes or deeper reach beyond the flute length. The micro scale leaves no margin for lateral force or misalignment.
Practical limits of the shank interface
The drill uses a standard shank that fits common pin vises and micro drill chucks. Run-out increases if the collet does not grip the full shank length. Excessive feed pressure snaps the flute because the cross-section is minimal at this scale.
Highlights
- Precision drilling with 1.05 mm diameter
- Micro-Tuff construction for extended tool life
- Twister flute design improves chip evacuation
- M.A. Ford quality for professional results
- California Prop 65 chemical warning applies
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Will the 1.05 mm Twister Micro-Tuff Drill fit the same pneumatic drill chuck I already use for 1 mm bits?
The 1.05 mm shank matches standard micro-drill chucks that accept 1 mm bits, so it fits without an adapter.
How can I confirm the 305M0105AM is cutting cleanly after I install it?
A steady, high-pitched whistle and consistent chip evacuation show the drill is running true at speed.
Does the box include any collets or lubricant, or must I buy them separately?
Only the single 1.05 mm drill is supplied; collets and cutting fluid are sold separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
