M.A. Ford
M.A. Ford Twister Micro-Tuff Drill 0.95 mm pneumatic accessory
A 0.95 mm Twister Micro-Tuff drill bit for precision pneumatic drilling tasks
- Precision micro-drilling with 0.95 mm diameter
- Twister Micro-Tuff design for tough material penetration
- M.A. Ford professional-grade manufacturing quality
- New condition ensures full factory performance
- California Prop 65 compliance disclosure included
Precision micro-drill for tight tolerances
The M.A. Ford Twister Micro-Tuff Drill measures 0.95 mm and is built for pneumatic use where fine hole accuracy matters. It suits technicians and engineers working on small-component assembly or repair tasks that demand a clean, repeatable cut.
Check shank fit and air supply before ordering
Verify that your pneumatic tool accepts the drill’s shank style and that your compressor delivers steady pressure at the required flow. The accessory carries a California Proposition 65 warning for chemicals linked to cancer and reproductive harm, so review safety data if your workplace tracks regulated substances.
Replaces worn micro-drills in high-cycle pneumatic
Swap it in when an existing 0.95 mm bit shows flank wear, chipping, or walk that degrades hole quality. The upgrade is worthwhile when downtime from frequent bit changes outweighs the cost of a fresh, factory-sharp cutter.
Highlights
- Precision micro-drilling with 0.95 mm diameter
- Twister Micro-Tuff design for tough material penetration
- M.A. Ford professional-grade manufacturing quality
- New condition ensures full factory performance
- California Prop 65 compliance disclosure included
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Does the M.A. Ford 305M0095AM Twister Micro-Tuff Drill come alone or with extra bits?
The 0.95 mm drill is supplied as a single accessory; no additional bits or holders are included in the package.
Is the 0.95 mm size the only diameter available in this Twister Micro-Tuff line?
The listing covers the 0.95 mm variant only; other diameters would appear under separate part numbers.
How does the 0.95 mm diameter affect hole quality in a pneumatic drill?
The fine 0.95 mm diameter is designed for precise micro-drilling in a pneumatic tool, producing small, accurate holes.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
