M.A. Ford
M.A. Ford Twister HPD Coolant HP Drill 5X 5/8 6250
High-performance coolant-fed drill bit drills five times diameter depth in a single pass
- 5X drilling depth speeds through thick material
- 5/8 inch diameter handles large holes
- Coolant-fed design clears chips and reduces heat
- Twister HPD geometry improves hole accuracy
- M.A. Ford quality built for professional use
M.A. Ford Twister HPD Drill 5X
The M.A. Ford Twister HPD Coolant HP Drill 5X is a high-performance drill built for demanding metalworking tasks. Its coolant-through design helps manage heat during deep-hole drilling. The tool targets professional machinists and fabricators who need reliable penetration in tough alloys. New condition ensures full factory performance from first use.
Suited for high-volume production drilling
This drill suits shops running high-volume production where coolant delivery extends tool life and maintains hole quality. It is not for handheld use or low-rigidity setups that cannot support through-coolant pressure. Buyers who need a general-purpose twist drill without coolant channels should look at something else. Operations lacking through-spindle coolant capability cannot use this tool as intended.
5/8 inch diameter with 5X diameter reach
The 5/8 inch cutting diameter combined with a 5X diameter drilling depth defines the working envelope for this tool. This single specification determines whether the drill matches your hole-depth and hole-size requirements. Verify your machine can deliver the coolant pressure and flow the design expects. Part number 6250 identifies this exact configuration in the M.A. Ford range.
Highlights
- 5X drilling depth speeds through thick material
- 5/8 inch diameter handles large holes
- Coolant-fed design clears chips and reduces heat
- Twister HPD geometry improves hole accuracy
- M.A. Ford quality built for professional use
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Does the Twister HPD coolant drill generate much heat or noise during extended drilling sessions?
The drill uses through-coolant delivery to manage heat at the cutting zone, reducing thermal buildup and keeping operating noise at typical high-performance drill levels.
What tool holder or machine spindle is required to run the 5/8 diameter shank?
A holder or spindle accepting a 5/8 inch straight shank is needed; the drill has no flats or whistle-notch, so a standard collet or hydraulic chuck of that bore size will secure it.
Can the HPDCR6250A replace an older solid-carbide drill in the same 5/8 size without changing feeds and speeds?
The 5X flute geometry and coolant-through design allow higher feed rates than conventional solid-carbide drills, so existing programmes should be reviewed and typically increased for best results.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
