M.A. Ford
M.A. Ford Twister Gp 3X Drill 4.00Mm pneumatic accessory
4 mm Twister GP 3X drill bit for high-performance pneumatic drilling applications
- Precision drilling with 4.00 mm Twister Gp 3X geometry
- M.A. Ford quality for reliable power tool performance
- New condition ensures full factory specification
- Manufacturer direct supply chain for consistent availability
- California Proposition 65 compliance disclosure included
Twister Gp 3X Drill 4.00Mm
The M.A. Ford Twister Gp 3X Drill is a 4.00 mm pneumatic accessory designed for precision drilling tasks. It suits metalworkers and maintenance technicians who need a reliable small-diameter cutting tool. The 22615750 model delivers consistent hole quality in professional workshop environments.
Sustained load behaviour
Under continuous pneumatic operation the drill maintains steady cutting action without the torque drop-off common in high-speed bursts. Heat builds gradually in the cutting zone, so periodic withdrawal clears chips and preserves edge life. The tool handles repetitive cycles when feed pressure stays controlled.
Installation and common issues
The shank fits standard pneumatic drill chucks and collets sized for 4.00 mm tools, so setup takes seconds. The most frequent problem is chip packing in deep holes when coolant or air blast is insufficient. California Proposition 65 warnings apply because the product contains listed chemicals.
Highlights
- Precision drilling with 4.00 mm Twister Gp 3X geometry
- M.A. Ford quality for reliable power tool performance
- New condition ensures full factory specification
- Manufacturer direct supply chain for consistent availability
- California Proposition 65 compliance disclosure included
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Does the 4.00 mm Twister Gp 3X Drill generate noticeable heat or noise during extended pneumatic use?
The drill is a pneumatic accessory with a 4.00 mm cutting diameter; heat and noise levels depend on the air supply and workpiece material rather than the bit itself.
What pneumatic tool or air supply is required to operate the 22615750 Twister Gp 3X Drill?
It requires a compatible pneumatic drill or driver capable of accepting a 4.00 mm shank accessory and delivering the recommended air pressure for the application.
Will the 4.00 mm Twister Gp 3X Drill fit older pneumatic chucks I already own?
The accessory uses a standard 4.00 mm shank, so it fits any pneumatic chuck or collet that accepts that diameter.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
