M.A. Ford
M.A. Ford Twister Gp 3X Drill 13.00Mm pneumatic accessory
Twister Gp 3X drill bit with 13.00 mm diameter for pneumatic drilling applications
- Twister Gp 3X geometry cuts faster
- 00 mm diameter suits standard chucks
- M.A. Ford brand backs professional quality
- New condition delivers full factory performance
- Part 22651180 identifies the exact tool
13.00 mm Twister Gp 3X Drill
The M.A. Ford Twister Gp 3X Drill is a 13.00 mm pneumatic accessory built for power-tool users who need a single cutting diameter. It is supplied new under manufacturer part number 22651180 and carries the brand’s standard construction. The drill suits workshops that run compressed-air systems and want a dedicated size for repetitive hole-making tasks.
Compatibility check before ordering
Verify that your pneumatic tool accepts a 13.00 mm shank and that your air supply delivers the pressure and flow the drill requires. Confirm the chuck or collet type matches the accessory so it seats securely without adapters. California Proposition 65 notices apply because the product contains chemicals known to cause cancer and birth defects or other reproductive harm.
Sustained-load behaviour
Under continuous operation the drill maintains its cutting geometry while the air motor runs at steady pressure. Heat builds gradually in the cutting zone rather than spiking in short bursts, so the tool relies on the compressed-air stream and workpiece material to carry heat away. Chip evacuation stays consistent as long as the air supply remains stable.
Highlights
- Twister Gp 3X geometry cuts faster
- 00 mm diameter suits standard chucks
- M.A. Ford brand backs professional quality
- New condition delivers full factory performance
- Part 22651180 identifies the exact tool
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What comes in the box with the M.A. Ford 22651180 Twister Gp 3X Drill and do I need to buy any extra parts?
The box contains the 13.00 mm Twister Gp 3X drill bit itself. No extra accessories or coolant are included, so have cutting fluid ready if your application requires it.
How do I know the 13.00 mm size is the right one for my job?
Match the 13.00 mm diameter to the hole size specified in your drawing or tap chart; the Twister Gp 3X geometry is designed for general-purpose drilling in steel, cast iron and similar materials.
What does the Proposition 65 warning mean for daily workshop use?
The drill contains a substance listed under California Proposition 65. Wear gloves, avoid inhaling dust when sharpening, and wash hands after handling to minimise exposure.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
