M.A. Ford
M.A. Ford Twister Coolant 10X Micro Drill 2.10 mm
A 2.10 mm micro drill with 10× coolant-through capability for deep precision holes
- Coolant-through design clears chips in deep holes
- 10× diameter reach drills deeper without pecking
- 10 mm diameter suits precision micro-drilling
- M.A. Ford brand trusted for high-performance tooling
- Prop 65 notice informs safe handling practices
M.A. Ford 10X Micro Drill
The M.A. Ford Twister Coolant 10X Micro Drill is a precision cutting tool manufactured for high-performance drilling tasks. It features a 2.10 mm diameter and a 10X length-to-diameter ratio for deep-hole applications. Integrated coolant channels deliver fluid directly to the cutting zone for heat management. This accessory targets machinists and maintenance technicians requiring accurate small-diameter holes.
Through-coolant design for deep holes
The through-coolant design evacuates chips efficiently during deep drilling cycles without external coolant supply lines. It fits standard tool holders compatible with micro drill shanks and high-pressure coolant systems. The geometry reduces pecking cycles, freeing up machine time and improving hole straightness. Users must verify holder runout and coolant pressure ratings match the tool requirements.
Suited for production micro drilling
This drill suits production environments drilling tough alloys, stainless steels, or hardened materials where chip control is critical. It is not for hand-held drilling, low-pressure coolant setups, or materials requiring larger diameter tooling. Buyers needing diameters outside 2.10 mm or different length ratios should select alternative tooling. Compliance with California Proposition 65 warnings is required for workplace safety.
Highlights
- Coolant-through design clears chips in deep holes
- 10× diameter reach drills deeper without pecking
- 10 mm diameter suits precision micro-drilling
- M.A. Ford brand trusted for high-performance tooling
- Prop 65 notice informs safe handling practices
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What spindle speed and coolant-pressure limits appear first when running this 10X micro drill continuously?
The drill is rated for 10X diameter depth; sustained use will hit the machine spindle's maximum rpm or the coolant system's pressure ceiling before the tool itself wears out.
How much noise, heat and power draw should I expect from this 2.10 mm drill during an all-day production run?
The carbide micro drill generates minimal heat at the cutting zone when fed with through-tool coolant; noise and power consumption are dictated by the host machine, not the drill.
What machine features must I already have to run this Twister Coolant 10X micro drill?
A spindle that accepts 2.10 mm shanks, through-spindle coolant capability and a sealed holder or collet that delivers coolant to the drill's internal channels are required.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
