M.A. Ford
M.A. Ford Twister Brad and Spur Drill No 6 20720400
Twister Brad and Spur Drill No 6 creates clean starter holes for precise woodworking and metal tasks
- Twister Brad and Spur design for clean drilling
- Size No 6 fits standard drill chucks
- M.A. Ford manufacturing for professional tool quality
- New condition ensures full cutting performance
- California Proposition 65 warning included for safety awareness
Twister Brad and Spur Drill No 6
The M.A. Ford Twister Brad and Spur Drill No 6 is a precision cutting accessory designed for woodworkers who need clean, accurate holes without splintering. Its brad-point tip centres the drill instantly while the spur edges score the wood fibres for a smooth entry and exit. This tool suits cabinetmakers, joiners and hobbyists who demand repeatable results in hardwoods and softwoods alike.
Proprietary Twister flute geometry
The Twister flute design evacuates chips efficiently, reducing heat buildup and binding during deep drilling. A standard round shank fits common drill chucks and quick-change adapters, so the bit works with corded drills, cordless drivers and drill presses without extra hardware. The hardened steel construction resists wear, keeping the cutting edges sharp over extended use in professional workshops.
Upgrades standard twist bits for fine woodwork
This drill replaces conventional twist bits when hole quality matters more than raw speed, eliminating tear-out on veneers and reducing sanding time on visible surfaces. The jump is worth it for furniture builders, instrument makers and anyone fitting hardware where a clean bore prevents costly rework. It is not suited for metal, masonry or high-volume production drilling where carbide tooling is required.
Highlights
- Twister Brad and Spur design for clean drilling
- Size No 6 fits standard drill chucks
- M.A. Ford manufacturing for professional tool quality
- New condition ensures full cutting performance
- California Proposition 65 warning included for safety awareness
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank type does the Twister Brad and Spur Drill No 6 use to fit a drill chuck?
It uses a standard round shank that clamps in any three-jaw drill chuck, so no special adapter is required.
What physical clearance does the drill need when boring a hole?
The bit length and flute length determine the depth you can reach; ensure the workpiece thickness plus any jig height does not exceed the usable flute length.
How is the drill installed and what step is often missed?
Open the chuck, insert the shank fully, tighten securely, then verify the bit runs true before starting the hole.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
