M.A. Ford
M.A. Ford Twister Brad and Spur Drill 5.80 mm 20722830
Drills precise 5.80 mm holes with a brad point and cutting spurs for clean entry and exit in wood
- Twister Brad and Spur drill design for clean wood boring
- 80 mm diameter suits precise pilot-hole requirements
- M.A. Ford brand recognised for professional cutting tools
- New condition ensures full factory performance
- Manufacturer-direct shipping on orders over $75
Twister Brad and Spur Drill 5.80 mm
The M.A. Ford Twister Brad and Spur Drill cuts precise 5.80 mm holes in wood and composite materials. Its brad point centres the bit without wandering and the spur edges shear fibres for a clean entry. The bit suits cabinetmakers, joiners and woodworkers who need accurate dowel or through holes.
Sustained drilling behaviour
The high-speed steel construction resists heat build-up during repeated drilling cycles. The flute geometry clears chips efficiently so the bit stays cooler and retains its edge longer than standard twist drills. This reduces the need for frequent sharpening on production runs.
Shank and day-to-day use
The straight shank fits standard drill chucks and quick-change adapters without slippage. The 20722830 marking allows easy re-ordering of the exact same specification. California Proposition 65 warnings apply because the coating contains listed chemicals.
Highlights
- Twister Brad and Spur drill design for clean wood boring
- 80 mm diameter suits precise pilot-hole requirements
- M.A. Ford brand recognised for professional cutting tools
- New condition ensures full factory performance
- Manufacturer-direct shipping on orders over $75
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Does the 5.80 mm Twister Brad and Spur Drill generate noticeable heat during extended use?
The drill bit itself produces heat only from friction in the workpiece; no motor or electronics are present to add thermal load.
What shank size must my drill chuck accept to hold the 5.80 mm bit?
The bit fits any standard chuck that closes down to 5.80 mm or smaller.
Will the 20722830 bit work in a cordless drill I already own?
Yes, it operates in any rotary drill that can secure a 5.80 mm shank.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
