M.A. Ford
M.A. Ford Twister Al 5X 3 Flute Drill No 10 22919350
Three-flute drill bit in size 10 cuts aluminium efficiently with five-times diameter reach
- Precision drilling with three-flute Twister Al 5X design
- Size 10 bit ready for immediate use
- New condition ensures full factory performance
- Manufacturer-direct quality from M.A. Ford
- California Proposition 65 chemical disclosure included
Twister Al 5X 3 Flute Drill No 10
The M.A. Ford Twister Al 5X is a three-flute drill designed for aluminium and similar non-ferrous materials. Its high-helix geometry promotes fast chip evacuation and reduces built-up edge during deep-hole operations. The tool carries part number 22919350 and is supplied new from the manufacturer.
Suited to CNC and manual drilling in aluminium
Shops cutting steel, titanium or hardened materials should select a drill with a different substrate and coating. The three-flute design is optimised for non-ferrous chip loads and will not perform well in abrasive or high-tensile alloys. Buyers needing coolant-through capability or a different shank style must look elsewhere.
California Proposition 65 notices apply
The product documentation states that the drill contains a chemical known to the State of California to cause cancer and birth defects or other reproductive harm. No additional coatings, surface treatments or bundled accessories are mentioned in the supplier data. Users should follow standard shop safety practices when handling and machining with this tool.
Highlights
- Precision drilling with three-flute Twister Al 5X design
- Size 10 bit ready for immediate use
- New condition ensures full factory performance
- Manufacturer-direct quality from M.A. Ford
- California Proposition 65 chemical disclosure included
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What chuck size do I need to hold the No 10 drill?
The No 10 drill requires a chuck that accepts its shank diameter; match the chuck capacity to the drill size for a secure grip.
Will the 5X flute design work with a standard variable-speed drill motor?
The three-flute geometry is compatible with common variable-speed drill motors; run at appropriate RPM for aluminium to avoid chip welding.
How can I confirm the drill is cutting correctly after setup?
Look for consistent, curled chips and a smooth hole wall; excessive heat or rough finish indicates incorrect speed or feed.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
