M.A. Ford
M.A. Ford Twister Al 5X 3 Flute Drill 33/64 22951560
Drills precise 33/64-inch holes in aluminium with five-times-diameter reach and three-flute chip evacuation
- Designed for aluminium with three-flute geometry
- 5x diameter reach for deeper holes
- 33/64 inch cutting diameter for precise sizing
- M.A. Ford quality for reliable performance
- California Prop 65 chemical warning applies
33/64 Twister Al 5X 3 Flute Drill
The M.A. Ford 22951560 is a solid-carbide drill with a 33/64 inch diameter and three flutes. It belongs to the Twister Al 5X series designed for aluminium and other non-ferrous materials. The tool is supplied new and ships directly from the manufacturer.
Machinists cutting aluminium or soft alloys
This drill suits workshops that need a dedicated 33/64 inch carbide tool for high-speed non-ferrous work. Shops that primarily drill steel, titanium or hardened alloys should select a geometry made for those materials.
Standard shank fits common holders
The straight shank installs in any compatible collet or drill chuck without adapters. Running the tool above recommended speeds for aluminium can cause built-up edge and premature wear, so verify parameters before cutting.
Highlights
- Designed for aluminium with three-flute geometry
- 5x diameter reach for deeper holes
- 33/64 inch cutting diameter for precise sizing
- M.A. Ford quality for reliable performance
- California Prop 65 chemical warning applies
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What size drill chuck is required to hold the 33/64 inch shank?
A chuck that opens to at least 33/64 inch is needed to grip the shank of the Twister Al 5X 22951560 drill bit.
Can this 3-flute drill be used in a standard handheld drill motor?
Yes, the 33/64 inch diameter shank fits common 1/2 inch capacity drill chucks found on many handheld drill motors.
How can I confirm the drill is cutting correctly after setup?
The three flutes should produce consistent, curled chips and the hole diameter should measure close to 33/64 inch when the drill is running true.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
