M.A. Ford
M.A. Ford Twister Al 5X 3 Flute Drill 3/64 22904690
Three-flute drill bit with five-times-diameter flute length for aluminium
- Designed for aluminium with Twister Al 5X geometry
- Three-flute design improves chip evacuation in soft metals
- 3/64 inch diameter suits precision drilling tasks
- Manufacturer part 22904690 ensures correct identification
- California Prop 65 warnings disclose chemical hazards
M.A. Ford Twister Al 5X drill bit
This M.A. Ford Twister Al 5X drill bit carries part number 22904690 and features a three-flute design. It is a new cutting tool intended for professional and industrial drilling tasks where the specific geometry matches the application requirements.
Suited for aluminium and similar materials
The three-flute Twister Al 5X geometry targets aluminium and comparable non-ferrous workpieces. Buyers who need a different diameter, flute count or coating for steel, titanium or composite materials should look at alternative tooling that matches those specific cutting conditions.
Verify toolholder and machine compatibility
Confirm that your spindle or chuck accepts the 3/64 inch shank and that your machine provides the speed and feed range recommended for this cutter. California Proposition 65 notices apply because the product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
Highlights
- Designed for aluminium with Twister Al 5X geometry
- Three-flute design improves chip evacuation in soft metals
- 3/64 inch diameter suits precision drilling tasks
- Manufacturer part 22904690 ensures correct identification
- California Prop 65 warnings disclose chemical hazards
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Which drill chuck size accepts the 3/64 shank on the Twister Al 5X 22904690?
Any standard chuck that grips a 3/64 inch shank will hold this drill securely.
Can I run the Twister Al 5X 22904690 in a corded drill that only reaches lower RPMs?
Yes, the drill bit will still cut in aluminium at reduced speeds, though material removal will be slower.
How do I confirm the Twister Al 5X 22904690 is cutting correctly after I start drilling?
Look for clean, curled aluminium chips and a round hole without excessive burrs or heat discoloration.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
