M.A. Ford
M.A. Ford Tuffcut Gp 4 Flute Ball Nose End Mill Stub 6.0mm 16523620
Four-flute ball-nose stub end mill with 6.0 mm diameter for contour milling
- 4-flute ball nose geometry produces smooth contour finishes
- Stub length increases rigidity for reduced deflection in tough materials
- 0 mm cutting diameter suits precise milling operations
- TuffCut GP series delivers reliable performance in general-purpose applications
- California Proposition 65 warning indicates regulated chemical content
Application
The M.A. Ford Tuffcut GP end mill is a 6.0 mm diameter rotary cutter with four flutes and a ball-nose profile. It suits machinists and maintenance teams who need to contour, profile or finish radii in a range of workpiece materials using standard milling equipment.
Build
The solid carbide construction resists wear and deflection during stub-length operations. A plain shank fits directly into ER collets, Weldon holders or shrink-fit adapters without proprietary hardware. The 16523620 part number ensures exact reorder identification for shop stores.
Operation
Short flute length reduces overhang, limiting vibration and heat buildup in the cut zone. Four flutes distribute chip load evenly, lowering cutting forces and audible noise on typical CNC or manual mills. No special coolant strategy is mandated by the tool geometry itself.
Highlights
- 4-flute ball nose geometry produces smooth contour finishes
- Stub length increases rigidity for reduced deflection in tough materials
- 0 mm cutting diameter suits precise milling operations
- TuffCut GP series delivers reliable performance in general-purpose applications
- California Proposition 65 warning indicates regulated chemical content
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank diameter does the 6.0 mm ball nose end mill require in the tool holder?
The cutter has a 6.0 mm shank, so it fits a 6.0 mm collet or Weldon holder without an adapter.
What minimum flute length clearance is needed for the stub-length cutter to engage the workpiece?
The stub design keeps the flute length short, so the spindle must reach the work with only a few millimetres of tool projection beyond the holder face.
How is the 4-flute ball nose end mill secured in a standard ER collet, and what step is often missed?
Insert the 6.0 mm shank fully into the collet, tighten the nut to the recommended torque, and verify run-out before cutting; skipping the torque check is the common error.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
