M.A. Ford
M.A. Ford Tuffcut Gp 4 Flute Ball Nose End Mill 9/16 14056250A
Four-flute ball-nose end mill cuts precise contours in metal and composite workpieces
- Four-flute design enables smooth contour milling
- Ball nose geometry produces precise 3-D profiles
- 9/16 inch diameter suits medium-size pocket work
- TuffCut GP coating extends tool life in steel
- California Proposition 65 warning lists cancer and reproductive risks
9/16 Ball Nose End Mill
The M.A. Ford Tuffcut GP 14056250 is a four-flute ball nose end mill designed for contouring and finishing operations. Its 9/16 inch diameter suits general-purpose milling in a range of materials. The tool targets machinists and fabricators who need reliable profile cutting performance. New condition ensures full cutting geometry life from the first pass.
Replaces Worn Two-Flute Ball Mills
Upgrading from a two-flute ball nose mill increases flute count for smoother finishes and higher feed rates in profiling work. The jump is worth it when surface quality matters more than chip clearance in deep pockets. Four flutes reduce chatter on rigid setups compared to fewer flutes. This end mill does not suit roughing passes where maximum chip evacuation is the priority.
Verify Shank And Holder Compatibility
Confirm your tool holder accepts the shank diameter before ordering. Check machine rigidity and spindle runout to avoid premature wear on the four-flute geometry. Ensure coolant or mist delivery matches the material being cut. California Proposition 65 warnings apply to this product.
Highlights
- Four-flute design enables smooth contour milling
- Ball nose geometry produces precise 3-D profiles
- 9/16 inch diameter suits medium-size pocket work
- TuffCut GP coating extends tool life in steel
- California Proposition 65 warning lists cancer and reproductive risks
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank diameter does the 9/16 in ball nose end mill need to fit a collet?
The cutter has a 9/16 in cutting diameter and a matching 9/16 in shank, so a 9/16 in collet or holder is required.
How do you install the 4 flute ball nose mill in a milling chuck without causing run-out?
Clean the shank and collet faces, insert the tool until the shank seats fully, then tighten the collet nut to the holder's rated torque in a star pattern.
When should the 14056250A end mill be replaced based on wear?
Replace the tool when the ball nose radius shows visible flats, chipping on the four flutes, or when surface finish degrades beyond tolerance.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
