M.A. Ford
M.A. Ford Tuffcut GP 2 Flute Ball Nose End Mill 7/64 15010930
A 7/64 inch two-flute ball-nose end mill for contour milling in general-purpose applications
- Two-flute ball nose cuts smooth contours
- 7/64 inch diameter suits fine detail work
- M.A. Ford TuffCut GP built for general purpose milling
- New condition guarantees full cutting performance
- California Proposition 65 warning informs safe handling
M.A. Ford 2-flute ball nose end mill
The M.A. Ford Tuffcut GP is a new solid-carbide end mill with two flutes and a ball nose profile. It is suited for general-purpose milling in a range of ferrous and non-ferrous materials where a radiused corner or full-radius contour is required.
7/64-inch diameter for standard tool holders
The 7/64-inch cutting diameter fits directly into collets or end-mill holders sized for that shank, allowing quick changes on CNC mills or manual machines. The two-flute geometry provides generous chip space for efficient evacuation in slotting and pocketing operations.
California Proposition 65 chemical warning applies
This product carries a Proposition 65 notice for substances identified by the State of California as causing cancer and reproductive harm. Buyers who must avoid listed chemicals entirely should select an alternative tool without such a warning.
Highlights
- Two-flute ball nose cuts smooth contours
- 7/64 inch diameter suits fine detail work
- M.A. Ford TuffCut GP built for general purpose milling
- New condition guarantees full cutting performance
- California Proposition 65 warning informs safe handling
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank diameter does the 7/64 ball nose end mill need for a standard collet?
The 7/64 cutting diameter matches a 7/64 shank, so use a collet or chuck that grips 7/64 inches precisely.
What tool holder style fits the TuffCut GP 15010930 in a CNC milling spindle?
It fits any ER collet, Weldon flat holder or shrink-fit chuck that accepts a 7/64 inch shank.
Which installation step is most often missed when seating this 2-flute end mill?
Fully seat the shank to the holder's back stop before tightening; a gap causes run-out and premature wear.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
