M.A. Ford
M.A. Ford Tuffcut GP 2 Flute Ball Nose End Mill 5.0 mm
Two-flute ball-nose end mill with a 5.0 mm cutting diameter for profiling and contouring operations
- 0 mm ball nose creates smooth 3D contours
- Two-flute design clears chips efficiently in deep pockets
- M.A. Ford TuffCut GP geometry resists wear in general-purpose milling
- 15019680 part number simplifies reordering and inventory tracking
- California Proposition 65 warning indicates regulated substances present
Cutting tool identity
This M.A. Ford Tuffcut GP end mill is a two-flute ball-nose cutter sized at 5.0 mm. It is manufactured for machining operations that require radius profiling, contouring or finishing passes in a variety of materials. The tool is supplied new and carries the manufacturer part number 15019680.
Accessory and software impact
No accessories, coatings or software are mentioned in the supplier data for this item. The product ships as a single cutting tool without additional hardware or digital licences. California Proposition 65 notices indicate the presence of chemicals linked to cancer and reproductive harm.
Suitability and alternatives
This cutter suits machinists who need a 5.0 mm ball-nose geometry for general-purpose milling. Buyers who require a different diameter, flute count or specialised coating should look at other tooling options. The listed free-shipping threshold of $75 applies to the order, not to the tool itself.
Highlights
- 0 mm ball nose creates smooth 3D contours
- Two-flute design clears chips efficiently in deep pockets
- M.A. Ford TuffCut GP geometry resists wear in general-purpose milling
- 15019680 part number simplifies reordering and inventory tracking
- California Proposition 65 warning indicates regulated substances present
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
When will the 5.0 mm ball nose need replacing?
Replace the end mill once the cutting edges show visible wear or chipping, as dull flutes increase cutting forces and reduce finish quality on the workpiece.
What limits continuous cutting with this 2 flute tool?
Heat buildup in the 5.0 mm cutting zone is the first limit; without adequate coolant or reduced feed rates the carbide can overheat and lose hardness.
How much noise and heat does the 5.0 mm end mill generate in all-day milling?
The tool itself runs quietly; most noise comes from the spindle and material removal, while heat concentrates at the 5.0 mm tip and must be managed with coolant or air blast.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
