M.A. Ford
M.A. Ford Tuffcut Al 2 Flute End Mill 16.0Mm 13562992
High-performance 16.0 mm aluminium end mill with two flutes for smooth milling
- TypeCutting Tools
- 0 mm diameter for precise milling cuts
- Two-flute geometry clears chips in aluminium
- TuffCut Al coating resists built-up edge
- California Prop 65 warning disclosed for safety
- New condition ensures full factory performance
M.A. Ford Tuffcut Al 16.0Mm End Mill
The M.A. Ford Tuffcut Al end mill is a two-flute cutting tool designed for aluminium machining. It carries the manufacturer part number 13562992 and is supplied new. The 16.0Mm cutting diameter suits CNC milling operations in workshop and production environments.
Suitable for aluminium milling.
This cutter is intended for machinists and fabricators working primarily with aluminium alloys. The two-flute geometry supports chip evacuation in non-ferrous metals. It is not suited for steel, titanium or abrasive composites, and buyers needing higher flute counts or different coatings should consider other tooling.
16.0Mm cutting diameter decides fit
The single specification that determines compatibility is the 16.0Mm cutting diameter. Your tool holder, spindle and programmed tool path must match this dimension exactly. California Proposition 65 warnings apply to this product.
Highlights
- 0 mm diameter for precise milling cuts
- Two-flute geometry clears chips in aluminium
- TuffCut Al coating resists built-up edge
- California Prop 65 warning disclosed for safety
- New condition ensures full factory performance
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
How often will the 16.0 mm cutting edges need resharpening or replacement?
Resharpen when flank wear reaches the maximum the shop allows; the carbide flutes can be reground several times before the shank diameter limits further service.
What limit appears first during a long profiling pass in aluminium?
Chip evacuation in deep slots becomes the bottleneck before the tool overheats, so use peck cycles or high-pressure coolant to clear the 2-flute gullets.
How much heat and noise does the cutter generate in continuous production?
The carbide body runs warm but not hot in aluminium; spindle and coolant pump noise dominate, while the tool itself adds only a light cutting hum.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
