M.A. Ford
M.A. Ford HPDCR 0530A Twister HPD Coolant Drill 5.30mm
A 5.30 mm diameter coolant-fed drill bit for high-performance drilling applications
- 30 mm diameter for precise hole sizing
- Twister HPD design for high-performance drilling
- Coolant-through capability for extended tool life
- 5x length ratio for deeper reach
- M.A. Ford quality for reliable results
M.A. Ford Twister HPD Coolant Drill 5.30mm
The M.A. Ford Twister HPDCR 0530A is a coolant-fed high-performance drill with a 5.30 mm cutting diameter. It is engineered for production drilling in tough alloys where through-tool coolant delivery improves chip evacuation and tool life. The 5X diameter design suits deep-hole applications in CNC machining centres.
Machinists drilling deep holes in stainless steel
This drill suits CNC operators who need reliable coolant-through performance at 5.30 mm diameter for deep-hole work. It is not for manual drilling, handheld tools or machines without through-spindle coolant capability. Buyers needing a different diameter or a non-coolant drill should select another tool.
5.30 mm coolant-through diameter
The 5.30 mm cutting diameter combined with internal coolant channels is the specification that determines fit. Verify the machine spindle accepts through-coolant and that the holder matches the shank before ordering. The tool carries a California Proposition 65 warning for chemicals known to cause cancer and reproductive harm.
Highlights
- 30 mm diameter for precise hole sizing
- Twister HPD design for high-performance drilling
- Coolant-through capability for extended tool life
- 5x length ratio for deeper reach
- M.A. Ford quality for reliable results
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What size collet or chuck do I need to hold the 5.30 mm shank of this HPDCR 0530A drill?
You need a collet or drill chuck that accepts a 5.30 mm diameter shank; the drill’s shank is ground to that exact size for a secure grip in standard tool holders.
Will the coolant-through channels in this Twister HPD drill work with my existing flood-coolant setup on an older CNC machine?
Yes, the internal coolant passages feed cutting fluid to the drill point, and they function with conventional flood or through-spindle coolant systems already on the machine.
How can I confirm the 5.30 mm Twister HPD drill is cutting correctly after installation?
Check for consistent chip evacuation, steady spindle load, and a clean hole finish at the expected diameter; these indicate the coolant-fed drill is performing as designed.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
