M.A. Ford
M.A. Ford DE1BM0300 PCD Ball End Mill 3mm 1 Flute
PCD ball end mill with 3 mm diameter and single flute for precision contouring
- PCD ball end mill delivers hard-material precision
- Single-flute design clears chips efficiently in tight cuts
- 3 mm diameter suits fine-detail milling tasks
- New M.A. Ford tooling ensures consistent factory quality
- California Proposition 65 notice flags regulated chemical content
3 mm PCD ball end mill
The M.A. Ford DE1BM0300 is a single-flute ball end mill with a 3 mm cutting diameter and a polycrystalline diamond tip. It is engineered for high-speed machining of abrasive non-ferrous materials such as graphite, composites and green carbide. The tool suits CNC operators who need extended tool life in these specific applications.
Upgrade from carbide ball mills
This PCD-tipped cutter replaces conventional carbide ball end mills when machining highly abrasive workpiece materials that rapidly wear standard carbide edges. The diamond layer maintains sharp geometry far longer, reducing tool-change frequency and improving surface finish consistency. The jump is justified when abrasive wear is the primary failure mode rather than chipping or thermal shock.
For abrasive non-ferrous work only
The cutter suits shops machining graphite electrodes, carbon-fibre composites, ceramics or high-silicon aluminium where abrasion destroys carbide tools quickly. It is not suited for ferrous alloys, hardened steels or interrupted cuts where the brittle diamond edge can fracture. Buyers needing a general-purpose mill for mixed materials should select a different substrate.
Highlights
- PCD ball end mill delivers hard-material precision
- Single-flute design clears chips efficiently in tight cuts
- 3 mm diameter suits fine-detail milling tasks
- New M.A. Ford tooling ensures consistent factory quality
- California Proposition 65 notice flags regulated chemical content
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank diameter does the DE1BM0300 require for a secure fit?
The DE1BM0300 is a 3 mm PCD ball end mill with a single flute, so the collet or holder must accept a 3 mm shank for proper mounting.
How is the DE1BM0300 installed and what step is often missed?
Clamp the 3 mm shank firmly in a matched collet, verify runout, and apply the correct feed for the single-flute PCD geometry; the step often missed is confirming the tool length offset before the first pass.
When will the DE1BM0300 need replacement or maintenance?
Replace the DE1BM0300 when the PCD ball tip shows flank wear or chipping that degrades surface finish; no re-sharpening is practical for the single-flute PCD design.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
