M.A. Ford
M.A. Ford Cyclone Xd 8X Coolant Fed Double Margin Drill 9.60Mm
Coolant-fed double-margin drill with 8x diameter depth capability for 9.60 mm holes
- Cyclone Xd design enables 8× diameter drilling depth
- Coolant-fed operation delivers fluid directly to the cutting zone
- Double-margin geometry improves hole straightness and surface finish
- 60 mm diameter suits precise metric hole requirements
- California Proposition 65 warning advises safe handling practices
M.A. Ford Cyclone Xd 8X Coolant Fed Drill
This M.A. Ford Cyclone Xd drill is a coolant fed double margin tool manufactured to a 9.60 mm diameter. It is built for precision drilling operations where controlled coolant delivery and hole stability are required. The design targets professional machining environments that demand consistent performance.
Suited for high precision drilling with coolant feed
Machinists needing a double margin drill with internal coolant channels for accurate hole making will find this tool appropriate. It is not intended for general purpose hand drilling or applications without coolant supply. Buyers who require a larger or smaller diameter must select a different size.
9.60 mm diameter defines the application
The 9.60 mm cutting diameter is the primary specification that determines fit for a specific hole size. Verify this exact measurement matches the required hole tolerance before purchase. California Proposition 65 warnings apply regarding chemical content.
Highlights
- Cyclone Xd design enables 8× diameter drilling depth
- Coolant-fed operation delivers fluid directly to the cutting zone
- Double-margin geometry improves hole straightness and surface finish
- 60 mm diameter suits precise metric hole requirements
- California Proposition 65 warning advises safe handling practices
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Will the 9.60 mm cutting edges need resharpening or replacement after extended use in tough alloys?
The solid-carbide Cyclone Xd drill can be reground several times by a specialist tool service; when the double-margin lands wear beyond tolerance the tool must be replaced.
What stops the CXDCLM0960AP from running continuously at full feed in deep holes?
The 8× diameter-to-length ratio means chip evacuation and coolant pressure become the practical limits before the shank or holder does.
How much heat and noise should I expect when this 9.60 mm drill runs all day in a CNC cell?
High-pressure coolant through the internal channels carries away most cutting heat, so spindle bearings stay cooler and noise remains at normal machining levels.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
