M.A. Ford
M.A. Ford Cyclone Xd 8X Coolant Fed Double Margin Drill 8.20Mm
Coolant-fed double-margin drill bit, 8.20 mm diameter, designed for deep-hole drilling with improved chip evacuation
- 8x coolant-fed design clears chips efficiently
- Double margin construction improves hole straightness and finish
- 20 mm diameter suits precise drilling tasks
- New condition ensures full tool life from start
- California Proposition 65 warning indicates regulated chemical content
Cyclone Xd 8X Drill 8.20Mm
The M.A. Ford Cyclone Xd 8X is a coolant-fed double margin drill manufactured for precision holemaking. It targets machinists and fabrication shops that require accurate deep-hole drilling in metal components. The 8.20 mm diameter suits specific bolt patterns and pilot-hole requirements. This tool is built for controlled material removal in demanding applications.
Thermal management and power use
Coolant-fed operation directs fluid through the tool to the cutting zone, managing heat during extended drilling cycles. The double margin design improves guidance and stability, reducing friction and cutting-force variation. Efficient heat evacuation lowers thermal load on both the workpiece and the drill body. Consistent coolant flow supports steady power draw on the machine spindle.
Coolant-fed double margin benefit
Internal coolant channels deliver lubricant directly to the cutting edges, improving chip evacuation in deep holes. Double margins maintain hole straightness and surface finish by guiding the drill at two contact points. This geometry reduces walk and vibration compared to single-margin drills. The combined features extend tool life and support tighter tolerances in production runs.
Highlights
- 8x coolant-fed design clears chips efficiently
- Double margin construction improves hole straightness and finish
- 20 mm diameter suits precise drilling tasks
- New condition ensures full tool life from start
- California Proposition 65 warning indicates regulated chemical content
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How do I install the CXDCLM0820AP drill in my CNC machine and which step is most often missed?
Mount the 8.20 mm shank in a precision collet or hydraulic holder, then engage the internal coolant port; the step most often missed is verifying that the coolant filter and pressure match the tool's 8X feed requirement before starting the cycle.
What maintenance or replacement will the double-margin drill need later?
Inspect both margins after each job for wear or chipping; plan to regrind the 8.20 mm diameter when flank wear reaches the manufacturer's limit, and replace the tool once regrind would drop the diameter below tolerance.
What limit appears first during sustained high-feed drilling with this 8X coolant-fed tool?
The coolant system's ability to evacuate chips at the 8X feed rate typically becomes the limiting factor before the carbide substrate reaches thermal limits.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
