M.A. Ford
M.A. Ford Cyclone Xd 8X Coolant Fed Double Margin Drill 4.30mm
Coolant-fed double-margin drill, 4.30 mm diameter, 8×D depth capability
- 8X diameter reach for deep-hole drilling
- coolant-fed design clears chips from the cut
- double-margin construction improves hole straightness
- 30 mm diameter suits precise metric work
- new condition ensures full factory performance
Cyclone Xd 8X Coolant Fed Drill
The M.A. Ford Cyclone Xd is a solid carbide drill with internal coolant channels and double margins. It is built for production environments that require deep, accurate holes in difficult materials. Machinists gain a tool that reduces cycle time while holding tight tolerances.
Sustained load behaviour
Internal coolant delivery flushes chips continuously during 8× diameter drilling. Double margins maintain hole straightness and surface finish when the cut runs long. The design resists deflection and thermal buildup that would degrade a standard drill under the same conditions.
Practical limits of the interface
The 4.30 mm diameter fixes the hole size and the matching coolant-hole geometry. Shank dimensions follow the manufacturer standard for this series, so holder compatibility is limited to that specification. Operators must verify machine spindle coolant pressure meets the drill’s minimum requirement.
Highlights
- 8X diameter reach for deep-hole drilling
- coolant-fed design clears chips from the cut
- double-margin construction improves hole straightness
- 30 mm diameter suits precise metric work
- new condition ensures full factory performance
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How much heat does the 4.30 mm drill generate during continuous coolant-fed operation?
The internal coolant channels carry fluid directly to the cutting zone, removing heat as the double-margin design maintains hole straightness during extended drilling cycles.
What tool-holder and coolant system are required to run the CXDCLM0430AP?
A machine spindle with through-coolant capability and a compatible 4.30 mm collet or hydraulic holder are needed to supply pressurised coolant through the drill body.
Will the 8X diameter flute length fit in the same tool magazine as my older 5X drills?
The longer flute increases overall tool length, so magazine pocket depth must be checked; the shank diameter remains standard for the 4.30 mm size.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
