M.A. Ford
M.A. Ford Cyclone Xd 8X Coolant Fed Double Margin Drill 19/64 7.54
Coolant-fed double-margin drill cuts 19/64 inch and 7.54 mm holes eight diameters deep
- Coolant-fed design extends tool life in deep holes
- Double-margin construction improves hole straightness and finish
- 8× diameter capability reduces need for peck drilling
- 19/64 inch diameter suits precise fractional sizing
- 54 mm metric equivalent matches international specs
Precision drilling tool for industrial metalwork
The M.A. Ford Cyclone Xd 8X Coolant Fed Double Margin Drill is built for high-performance drilling in demanding metalworking applications. Its 19/64 inch diameter and 7.54 mm metric equivalent suit precision hole-making tasks. The double margin design improves hole straightness and surface finish. Coolant-fed operation helps manage heat and extend tool life during deep cuts.
Coolant-fed design changes chip control
Internal coolant delivery flushes chips directly from the cutting zone, reducing the risk of clogging in deep holes. The double margin geometry adds a second guiding surface, which stabilises the drill and improves roundness compared with single-margin alternatives. These features combine to support consistent performance in tough alloys and high-volume production runs.
Check machine compatibility and safety requirements
Verify that your machine spindle accepts the shank style and can supply coolant through the tool at the required pressure. Confirm the workpiece material matches the drill’s intended cutting range. Note the California Proposition 65 warnings: this product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
Highlights
- Coolant-fed design extends tool life in deep holes
- Double-margin construction improves hole straightness and finish
- 8× diameter capability reduces need for peck drilling
- 19/64 inch diameter suits precise fractional sizing
- 54 mm metric equivalent matches international specs
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How often will the double margin drill need re-sharpening when cutting hardened steel?
The Cyclone Xd 8X design uses double margins for guidance; re-sharpening interval depends on material hardness and coolant flow rather than a fixed cycle.
What limits continuous drilling depth with the 19/64 inch coolant-fed shank?
Chip evacuation through the internal coolant channel and the 8x diameter flute length set the practical depth limit before pecking is required.
How much heat builds up in the CXDCL2969AP body during an all-day production run?
Internal coolant delivery carries heat directly from the cutting zone, keeping the drill body temperature far lower than external flood cooling alone.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
