M.A. Ford
M.A. Ford Cyclone Xd 5X Solid Double Margin Drill No 21
Solid double-margin drill No 21 delivers 5X performance for precision drilling tasks
- 5X solid design improves hole straightness and tool life
- Double margin construction enhances guidance and surface finish
- Cyclone Xd geometry optimises chip evacuation in deep holes
- Drill No 21 targets specific diameter applications
- Prop 65 notice lists chemical hazards for California compliance
Cyclone Xd 5X Drill No 21
The M.A. Ford Cyclone Xd 5X Solid Double Margin Drill No 21 is a precision cutting tool built for demanding machining tasks. Its solid double margin design supports hole accuracy and stability during operation. This accessory targets professional machinists and maintenance crews who require reliable performance in production environments. It ships new directly from the manufacturer.
Upgrade from standard twist drills
This drill replaces conventional twist drills when tighter tolerances and longer tool life are needed. The 5X geometry and double margin construction reduce vibration and improve chip evacuation in deep holes. The jump is worth it when hole quality directly affects assembly fit or when regrinding intervals must be extended. Operators gain consistency across repeated cycles.
Sustained load behaviour
Under continuous cutting forces the solid carbide body and double margins resist deflection better than single margin alternatives. Heat distributes evenly along the flute length, delaying edge breakdown during long runs. The design maintains diameter control through extended engagements without the wandering seen in lighter tools. California Proposition 65 warnings apply for chemical exposure.
Highlights
- 5X solid design improves hole straightness and tool life
- Double margin construction enhances guidance and surface finish
- Cyclone Xd geometry optimises chip evacuation in deep holes
- Drill No 21 targets specific diameter applications
- Prop 65 notice lists chemical hazards for California compliance
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What size chuck is needed for the No 21 drill?
The No 21 drill uses a standard shank that fits a 1/4 inch or 6 mm chuck on most cordless or corded drills.
How do I install the CXDSR1590AP bit without it walking?
Start the hole at low speed with light pressure until the double margin engages, then increase speed; skipping the slow start lets the bit wander.
When should I replace the Cyclone Xd 5X drill?
Replace it when the cutting lips show visible rounding or the margins lose their sharp edge, typically after drilling several hundred holes in steel.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
