M.A. Ford
M.A. Ford Cyclone Xd 5X Solid Double Margin Drill 6.00 mm
A 6.00 mm solid double-margin drill designed for 5× diameter depth drilling
- Cyclone Xd geometry drills five diameters deep
- Double-margin design improves hole straightness and stability
- 00 mm cutting diameter suits precise metric holes
- Solid carbide construction resists wear in tough materials
- California Proposition 65 warning applies to this product
6.00 mm solid carbide drill
The M.A. Ford Cyclone Xd 5X is a solid carbide drill with a 6.00 mm diameter and double margin design. It is built for machinists and maintenance technicians who need accurate holes in tough materials. The 5X diameter flute length supports deeper drilling without pecking.
Double margin stability
The double margin geometry guides the tool to reduce vibration and improve hole straightness during normal use. Solid carbide construction handles the heat generated at higher cutting speeds. Consistent chip evacuation keeps power draw steady across the cut.
Fits standard 6.00 mm tool holders
The 6.00 mm shank fits directly into collets, hydraulic holders or shrink-fit systems sized for that diameter. No bushings or sleeves are required, freeing up tool changer slots. California Proposition 65 warnings apply to this product.
Highlights
- Cyclone Xd geometry drills five diameters deep
- Double-margin design improves hole straightness and stability
- 00 mm cutting diameter suits precise metric holes
- Solid carbide construction resists wear in tough materials
- California Proposition 65 warning applies to this product
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How do I install the 6.00 mm Cyclone Xd 5X drill in my drill press and what step is often missed?
Secure the 6.00 mm shank fully in the chuck, then verify the double-margin lands run true before starting; the step most often missed is checking concentricity at the margins.
What maintenance or replacement will the CXDSR 0600AP need after extended use?
The solid-carbide body cannot be resharpened economically; once the cutting edges dull or the double margins wear, replace the entire 6.00 mm drill.
What limit appears first when drilling deep holes continuously with this 5X tool?
Chip evacuation through the 5X flute length becomes the limiting factor; peck-drilling or through-coolant is required to prevent packing and breakage.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
