M.A. Ford
M.A. Ford Cyclone Xd 5X Solid Double Margin Drill 5.10mm
Solid double-margin drill bit cuts precise 5.10 mm holes in tough materials
- 5x diameter drilling depth reduces cycle time
- Double margin design improves hole straightness and finish
- Solid carbide construction maintains rigidity in tough materials
- 10 mm diameter suits precise metric hole requirements
- Cyclone Xd geometry optimises chip evacuation for productivity
Cyclone Xd 5X Drill — 5.10 mm diameter
The M.A. Ford Cyclone Xd 5X is a solid double-margin drill built for high-precision holemaking in demanding materials. Its 5.10 mm cutting diameter suits applications that require tight tolerance and consistent finish. The tool is sold new and ships directly from the manufacturer.
Designed for rigid machining setups
The double-margin geometry improves hole straightness and surface quality by guiding the drill at two contact points. It requires a stable machine spindle and appropriate workholding to realise its accuracy potential. The design frees the operator from frequent regrinds by maintaining performance over extended production runs.
California Proposition 65 notice included
The supplied documentation flags that the product contains a chemical known to the State of California to cause cancer and birth defects or other reproductive harm. This regulatory notice informs workplace safety planning and handling procedures. No additional accessories or software are bundled with the drill.
Highlights
- 5x diameter drilling depth reduces cycle time
- Double margin design improves hole straightness and finish
- Solid carbide construction maintains rigidity in tough materials
- 10 mm diameter suits precise metric hole requirements
- Cyclone Xd geometry optimises chip evacuation for productivity
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How deep can the 5.10 mm Cyclone Xd drill go before chip evacuation becomes the limiting factor?
The solid double-margin design keeps chips moving in deep holes, but the practical depth limit depends on workpiece material, coolant pressure and your machine’s peck cycle.
What heat or noise level should I expect when running this 5.10 mm drill continuously in a CNC cycle?
Heat and noise are dictated by spindle speed, feed rate and coolant setup rather than the drill itself; monitor tool temperature and adjust parameters accordingly.
Which tool-holding system do I already need to mount the CXDSR 0510AP shank?
The drill uses a standard cylindrical shank; match it to a collet, hydraulic chuck or shrink-fit holder that accepts the shank diameter.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
