M.A. Ford
M.A. Ford Cyclone Xd 5X Solid Double Margin Drill 3.30 mm
Solid double-margin drill bit, 3.30 mm diameter, for high-precision drilling
- Cyclone Xd 5X geometry drills 5× faster
- Solid carbide construction resists wear in tough alloys
- Double margin design keeps holes straight and round
- 30 mm diameter fits precise pilot-hole requirements
- California Proposition 65 warning flags chemical hazards
M.A. Ford Cyclone Xd 5X Drill 3.30 mm
This solid carbide drill is built for high-performance drilling in tough materials. The double margin design improves hole straightness and surface finish. It suits professional machinists and maintenance teams who need reliable results in steel and alloys. The 5x diameter flute length supports deeper holes without pecking.
California Proposition 65 notice applies
This product contains a chemical known to the State of California to cause cancer and birth defects or other reproductive harm. Users should follow standard workshop safety practises including dust extraction and personal protective equipment. The drill itself generates heat and cutting forces typical of solid carbide tooling in normal operation.
3.30 mm cutting diameter
The 3.30 mm diameter determines the hole size this drill produces. It is the single specification that decides whether the tool matches the required bore for tapping, reaming or clearance fits. Verify the drawing or bill of materials calls for this exact metric size before ordering.
Highlights
- Cyclone Xd 5X geometry drills 5× faster
- Solid carbide construction resists wear in tough alloys
- Double margin design keeps holes straight and round
- 30 mm diameter fits precise pilot-hole requirements
- California Proposition 65 warning flags chemical hazards
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How do I install the 3.30 mm Cyclone Xd drill in a chuck without damaging the double margins?
Use a collet or three-jaw chuck sized for 3.30 mm shanks, tighten evenly so both margins seat fully, and avoid side-loading during insertion.
When will the 3.30 mm Cyclone Xd drill need replacement?
Replace when the cutting lips show visible wear, the double margins lose their clearance, or hole diameter exceeds tolerance for the application.
What limit appears first when drilling deep holes with the 3.30 mm Cyclone Xd at sustained feed?
Chip evacuation through the 5X flute length becomes the limiting factor before the solid carbide body reaches thermal limits.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
