M.A. Ford
M.A. Ford Cyclone Xd 5X Coolant Fed Double Margin Drill No 29
A coolant-fed double-margin drill in size No 29 designed for 5× diameter depth drilling
- Coolant-fed design improves chip evacuation for deeper holes
- Double margin construction enhances hole straightness and surface finish
- 5× diameter reach extends drilling capability in tough materials
- Size No 29 matches precise pilot-hole requirements
- California Proposition 65 warning informs safe handling practices
Cyclone Xd 5X Coolant-Fed Drill No 29
The M.A. Ford Cyclone Xd 5X is a coolant-fed double margin drill designated No 29 for precision holemaking. It targets machinists who require controlled chip evacuation and straightness in deep drilling applications. The tool arrives new and ships directly from the manufacturer.
Double Margin Design For Guided Cutting
Two margins guide the drill within the hole to maintain alignment and improve surface finish. Internal coolant channels deliver fluid to the cutting zone, reducing heat buildup and extending tool life. This configuration frees the operator from relying on external flood coolant for deep holes.
Sustained Load Performance With Coolant Feed
Continuous coolant flow stabilises temperatures during extended cuts, preventing thermal degradation of the cutting edges. The double margin geometry resists deflection under sustained feed pressure. California Proposition 65 warnings apply for cancer and reproductive harm.
Highlights
- Coolant-fed design improves chip evacuation for deeper holes
- Double margin construction enhances hole straightness and surface finish
- 5× diameter reach extends drilling capability in tough materials
- Size No 29 matches precise pilot-hole requirements
- California Proposition 65 warning informs safe handling practices
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How deep can the No 29 drill cut before chip evacuation becomes the limiting factor?
The 5X coolant-fed design with double margins sustains chip removal at five times the diameter, so depth is limited by your machine travel rather than flute clogging.
What spindle power and coolant pressure are needed to run the CXDCR1360AP continuously without overheating?
M.A. Ford recommends matching the drill to a rigid CNC spindle and supplying coolant at the pressure specified for 5X operation to control heat during all-day cycles.
Which tool holders and machine interfaces accept the CXDCR1360AP shank for immediate use?
The drill fits standard CNC holders that match its shank diameter; verify your holder collet or hydraulic chuck size before ordering.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
