M.A. Ford
M.A. Ford Cyclone Xd 5X Coolant Fed Double Margin Drill 5.20 mm
Coolant-fed double-margin drill with 5.20 mm diameter for efficient chip removal
- Coolant-fed design improves chip evacuation during deep drilling
- Double-margin construction enhances hole straightness and surface finish
- 5X diameter capability reduces tool changes in production
- 20 mm cutting diameter suits precise metric applications
- M.A. Ford engineering delivers consistent performance in tough materials
Precision drilling tool
The M.A. Ford Cyclone Xd 5X is a coolant-fed double margin drill with a 5.20 mm diameter. It is manufactured for machining operations that require accurate hole placement and consistent finish. The tool suits professional machinists and maintenance workshops.
Application fit
This drill suits users who need through-coolant capability and double-margin stability for deep or difficult holes. Buyers who require a different diameter or a non-coolant-fed design should look at other options. The product carries a California Proposition 65 warning for cancer and reproductive harm.
Sustained operation
Coolant delivery through the tool helps manage heat during extended drilling cycles. The double margin design supports alignment and reduces wandering over long cuts. This construction promotes steady performance under continuous load rather than only in short bursts.
Highlights
- Coolant-fed design improves chip evacuation during deep drilling
- Double-margin construction enhances hole straightness and surface finish
- 5X diameter capability reduces tool changes in production
- 20 mm cutting diameter suits precise metric applications
- M.A. Ford engineering delivers consistent performance in tough materials
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What machine spindle and coolant system do I need to run a 5.20 mm coolant-fed drill?
You need a machine spindle that accepts a 5.20 mm shank and a through-spindle coolant system capable of delivering coolant at the pressure recommended for the CXDCR 0520AP drill.
Can I use this 5X drill in a holder or machine that only supports shorter 3X tools?
The CXDCR 0520AP has a 5X length-to-diameter ratio, so it requires a holder and machine clearance suited to that longer reach; a 3X-only setup will not accommodate it.
How do I verify the drill is cutting correctly after installation?
Check that coolant flows steadily from the drill point, listen for a consistent cutting sound, and measure the first holes to confirm they meet the 5.20 mm diameter and depth tolerance.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
