M.A. Ford
M.A. Ford Cyclone Xd 5X Coolant Fed Double Margin Drill 21/64
Coolant-fed double-margin drill with 5× diameter reach for 21/64 inch holes
- Coolant-fed design improves chip evacuation and tool life
- Double-margin construction enhances hole accuracy and surface finish
- 5× diameter reach enables deeper drilling in one pass
- 21/64 inch diameter suits precise hole-sizing requirements
- Brand-new M.A. Ford quality for reliable performance
21/64 Cyclone Xd drill identity
The M.A. Ford Cyclone Xd is a 5X coolant-fed double-margin drill sized at 21/64. It targets machinists who need a rigid, high-penetration tool for deep-hole work in tough alloys. The double-margin design improves hole straightness and surface finish while the internal coolant path evacuates chips efficiently. This item ships new directly from the manufacturer.
Upgrade from standard jobber drills
Conventional jobber-length drills lack the length-to-diameter ratio and through-coolant capability required for consistent 5X-depth holes. The jump is worth it when hole depth exceeds three diameters, when chip packing causes wander, or when coolant pressure is needed to break and flush chips in materials such as stainless steel or titanium. Buyers who only drill shallow holes in mild steel will not use the extra length or coolant feed.
Build fit: holder, coolant, workpiece
The shank fits standard tool holders that accept the 21/64 diameter; the machine must supply high-pressure coolant through the spindle to activate the internal channels. Rigid workholding and a stable spindle are essential because the 5X projection amplifies any run-out. The drill frees the operator from peck cycles and reduces cycle time by clearing chips in a single pass. California Proposition 65 warnings apply to chemicals present in the product.
Highlights
- Coolant-fed design improves chip evacuation and tool life
- Double-margin construction enhances hole accuracy and surface finish
- 5× diameter reach enables deeper drilling in one pass
- 21/64 inch diameter suits precise hole-sizing requirements
- Brand-new M.A. Ford quality for reliable performance
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank diameter does the 21/64 drill need for a secure fit?
The 21/64 inch diameter shank fits standard drill chucks and tool holders sized for that fractional dimension.
How do I install the coolant-fed drill so the internal channels stay clear?
Connect the coolant supply to the drill's inlet port before spinning, ensuring the double-margin flutes stay flushed during the 5X depth cut.
When should the double-margin drill be replaced to maintain hole quality?
Replace the drill when the margins show visible wear or when hole tolerance exceeds the 21/64 specification.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
