M.A. Ford
M.A. Ford Cyclone Xd 3X Solid Double Margin Drill No 21
Solid double-margin drill No 21 designed for 3× diameter depth drilling
- Solid double-margin design improves hole straightness in deep drilling
- Cyclone Xd 3X construction extends tool life in tough materials
- Drill number 21 matches precise hole-size requirements
- California Proposition 65 warning informs safe handling practices
- Ships directly from M.A. Ford for authentic quality assurance
Cyclone Xd 3X Drill No 21
The M.A. Ford Cyclone Xd 3X is a solid double margin drill designated No 21. It belongs to the power and pneumatic accessories category for automotive and general workshop use. The tool is supplied new and ships directly from the manufacturer. It carries California Proposition 65 warnings for chemicals known to cause cancer and reproductive harm.
Sustained drilling behaviour
The solid double margin design supports hole stability and alignment during extended cutting cycles. This construction helps maintain consistent performance when the drill is under continuous load rather than intermittent use. The 3X designation indicates a specific geometry intended for demanding applications. Operators should observe the Proposition 65 safety notices during prolonged handling.
Upgrade context
This drill replaces standard single margin bits where improved guidance and finish are required. The jump is worth it when hole straightness and surface quality are priorities over basic material removal. It is not suited for buyers needing coated or carbide tipped variants for abrasive alloys. The No 21 sizing limits compatibility to matching tool holders and collets.
Highlights
- Solid double-margin design improves hole straightness in deep drilling
- Cyclone Xd 3X construction extends tool life in tough materials
- Drill number 21 matches precise hole-size requirements
- California Proposition 65 warning informs safe handling practices
- Ships directly from M.A. Ford for authentic quality assurance
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Does the Cyclone Xd 3X drill No 21 generate noticeable heat or vibration during extended use?
The drill is designed for efficient chip evacuation with its double-margin geometry, which helps control heat buildup during continuous drilling operations.
What tool holder or chuck is required to run the CXDSS1590AP drill?
The shank fits standard drill chucks and collets used with portable drills or drill presses, so no special holder is needed beyond a correctly sized chuck.
Will the No 21 Cyclone Xd drill work reliably in older drill presses with lower spindle speeds?
Yes, the solid-carbide construction and 3X diameter flute length perform well across a wide speed range, including the lower RPMs typical of older machines.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
