M.A. Ford
M.A. Ford Cyclone Xd 3X Solid Double Margin Drill 9.00 mm
A 9.00 mm solid double-margin drill for accurate three-times-diameter holes
- 00 mm diameter creates precise holes in metal
- Cyclone Xd geometry removes chips faster during deep drilling
- Double margin design keeps the drill straight for tighter tolerances
- 3X solid carbide construction resists wear in abrasive alloys
- California Proposition 65 warning indicates regulated substances present
Cyclone Xd 3X Double Margin Drill
The M.A. Ford Cyclone Xd 3X is a solid double margin drill built for precision holemaking. Its 9.00 mm diameter suits metalworking tasks that demand accurate sizing and straightness. The tool arrives new and ready for use in professional workshops.
Suited for controlled drilling in metal
This drill serves machinists who need consistent performance in ferrous and non-ferrous materials. The double margin design improves hole quality and tool life. It is not intended for woodworking, masonry or handheld drilling without a rigid setup. Buyers needing larger diameters or coated variants should look elsewhere.
9.00 mm diameter with solid construction
The 9.00 mm cutting diameter handles close-tolerance holes in a single pass. Solid carbide construction provides rigidity for deeper cuts without deflection. Headroom decreases in abrasive alloys or interrupted cuts where specialised coatings would extend life. The tool meets the requirements indicated by the Proposition 65 notices.
Highlights
- 00 mm diameter creates precise holes in metal
- Cyclone Xd geometry removes chips faster during deep drilling
- Double margin design keeps the drill straight for tighter tolerances
- 3X solid carbide construction resists wear in abrasive alloys
- California Proposition 65 warning indicates regulated substances present
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What power tool do I need to run the 9.00 mm Cyclone Xd drill?
It fits any drill press, pillar drill or handheld drill that accepts a 9.00 mm shank and can deliver the speed and feed rate recommended for the material you are cutting.
Can the 9.00 mm Cyclone Xd drill be used in the same drill press as my older bits?
Yes, as long as the chuck or collet accepts a 9.00 mm shank; the double-margin design does not change the mounting interface.
How can I confirm the 9.00 mm Cyclone Xd drill is cutting correctly after setup?
Check for a steady, quiet cut, consistent chip formation and a hole diameter that matches the 9.00 mm spec without oversize or chatter.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
