M.A. Ford
M.A. Ford Cyclone XD 3X Solid Double Margin Drill 5.70 mm
A 5.70 mm solid double-margin drill for precise, stable holes in tough materials
- 3X drilling depth reduces cycle time
- Solid carbide construction resists wear
- Double margin design improves hole accuracy
- 70 mm diameter suits precise applications
- Cyclone XD geometry enhances chip evacuation
Cyclone XD 3X Drill 5.70 mm
The M.A. Ford Cyclone XD 3X is a solid double-margin drill bit sized at 5.70 mm. It is built for machine shops and maintenance teams that need accurate holes in tough materials. The rigid construction supports consistent performance in CNC and manual drilling operations. Buyers who need a larger diameter or a coolant-through design should look elsewhere.
5.70 mm cutting diameter
The single specification that decides fit is the 5.70 mm cutting diameter. This exact size must match the hole requirement in the drawing or the tap chart for the intended thread. No other diameter will satisfy the tolerance for this specific application. Verify the required size before ordering to avoid mismatched holes.
Straight-shank installation
The drill uses a straight shank that locks into standard collets, drill chucks or tool holders. Secure clamping prevents run-out and extends tool life in high-speed cycles. A common issue is insufficient holder grip, which leads to slippage and oversized holes. Clean the shank and holder faces before tightening to ensure full contact.
Highlights
- 3X drilling depth reduces cycle time
- Solid carbide construction resists wear
- Double margin design improves hole accuracy
- 70 mm diameter suits precise applications
- Cyclone XD geometry enhances chip evacuation
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How does the 5.70 mm diameter translate to hole size and drill life in a CNC machine?
The 5.70 mm diameter produces a hole within standard tolerance for that size, and the double-margin design improves guidance and finish in deeper cuts.
What shank standard does the CXDSS 0570AP use, and what tool holders accept it?
It uses a common cylindrical shank sized for the 5.70 mm body, fitting standard collets, hydraulic chucks and shrink-fit holders for that diameter.
What machine rigidity and coolant setup does this solid carbide drill need?
It requires a rigid spindle and stable workholding to prevent vibration, and performs best with through-coolant or high-pressure external coolant to evacuate chips.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
