M.A. Ford
M.A. Ford Cyclone Xd 3X Solid Double Margin Drill 15.50mm
Solid double-margin drill bit cuts 15.50 mm holes with Cyclone Xd 3X geometry
- 3X solid construction extends drill life for heavy-duty use
- Double margin design improves hole straightness and finish
- 50 mm diameter suits precise metric drilling tasks
- Cyclone Xd coating resists wear in abrasive materials
- California Proposition 65 warning informs safe handling practices
15.50mm Cyclone Xd Drill
The M.A. Ford Cyclone Xd is a solid carbide drill featuring a 3X diameter flute length and a double margin design. It is engineered for high-performance drilling in a range of materials including steel and cast iron. The 15.50mm cutting diameter suits precise holemaking requirements in professional machining environments.
For high-accuracy production drilling
This tool suits machinists and manufacturers who need a rigid, short-length drill for accurate hole placement and finish. The double margins improve guidance and stability in deeper holes up to three times the diameter. It is not intended for applications requiring longer reach, coolant-through capability, or larger diameter sizes.
15.50mm cutting diameter
The drill cuts a nominal hole size of 15.50mm, which is the primary specification for matching the tool to the required bore. The 3X flute length defines the maximum effective drilling depth relative to this diameter. Verify the hole tolerance and depth requirement against these figures before selection.
Highlights
- 3X solid construction extends drill life for heavy-duty use
- Double margin design improves hole straightness and finish
- 50 mm diameter suits precise metric drilling tasks
- Cyclone Xd coating resists wear in abrasive materials
- California Proposition 65 warning informs safe handling practices
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank size must my drill chuck accept for the 15.50mm Cyclone Xd bit?
The drill has a 15.50mm cutting diameter; ensure your chuck capacity meets or exceeds that size for a secure grip.
Will the 3X solid double-margin design reduce wandering when I use it with an older drill press?
The double-margin geometry improves guidance and hole straightness even on less rigid or older machines.
How can I confirm the CXDSS 1550AP is cutting correctly after setup?
Check for a clean, round hole at the 15.50mm diameter with minimal burr and consistent chip evacuation.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
