M.A. Ford
M.A. Ford Cyclone Xd 3X Coolant Fed Double Margin Drill No 31
Cyclone Xd coolant-fed drill with double-margin design for precise hole-making
- Cyclone Xd design delivers 3X coolant-fed drilling efficiency
- Double margin construction improves hole accuracy and tool stability
- Size No 31 optimised for precise small-diameter applications
- California Proposition 65 compliance ensures regulated chemical transparency
- Ships directly from M.A. Ford for factory-fresh condition
Cyclone Xd 3X Coolant-Fed Drill
The M.A. Ford Cyclone Xd 3X is a coolant-fed double margin drill designated No 31. It is built for precision holemaking in demanding machining environments where consistent coolant delivery and hole straightness are critical. Professional machinists and CNC operators use it to maintain tight tolerances in production drilling applications.
Thermal management and power efficiency
The 3X coolant-fed design channels fluid directly to the cutting zone, controlling heat generation during normal operation. Double margins provide stability that reduces vibration and cutting noise while maintaining efficient power draw through the spindle. This configuration supports steady material removal rates without excessive thermal buildup in the workpiece or tool body.
Sustained-load behaviour
Under continuous drilling cycles the internal coolant passages maintain consistent temperature control at the cutting edges. The double margin geometry resists deflection over long cuts, preserving hole quality and dimensional accuracy where non-coolant drills might wander. This allows the tool to complete deep-hole operations without the degradation seen in short-burst testing.
Highlights
- Cyclone Xd design delivers 3X coolant-fed drilling efficiency
- Double margin construction improves hole accuracy and tool stability
- Size No 31 optimised for precise small-diameter applications
- California Proposition 65 compliance ensures regulated chemical transparency
- Ships directly from M.A. Ford for factory-fresh condition
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How do I install the CXDCS1200AP Cyclone Xd No 31 drill in a coolant-fed holder, and what step is often missed?
Clamp the double-margin shank in a compatible coolant-fed holder, align the internal coolant port with the spindle feed, and torque to the holder maker's spec; the step most often missed is verifying that the coolant channel lines up before tightening.
What maintenance or replacement will the CXDCS1200AP Cyclone Xd No 31 drill need over time?
Inspect the cutting lips and double margins for wear after each job; re-grind or replace the drill when flank wear reaches the holder maker's limit, and flush the internal coolant passage with solvent whenever chips accumulate.
What limit appears first on the CXDCS1200AP Cyclone Xd No 31 drill during sustained high-speed drilling?
The internal coolant passage can clog with fine chips during long runs, cutting off lubrication and causing rapid margin wear before the cutting edges themselves fail.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
