M.A. Ford
M.A. Ford Cyclone XD 3X Coolant Fed Double Margin Drill 5/32
Coolant-fed double-margin drill bit with 3× diameter flute length for efficient chip evacuation
- Coolant-fed design clears chips for deeper holes
- Double-margin construction improves hole straightness and finish
- 3× diameter reach extends drilling capability
- 5/32 inch diameter suits precise fastening tasks
- New M.A. Ford drill ready for immediate use
Cyclone XD 3X Coolant-Fed Drill
The M.A. Ford Cyclone XD 3X is a coolant-fed double margin drill built for precision holemaking in demanding materials. It targets machinists and fabricators who need reliable chip evacuation and hole straightness during deep drilling cycles. The tool arrives new and ships directly from the manufacturer. Its specialised geometry supports consistent performance in high-volume production environments.
Coolant-Fed Double Margin Design
Internal coolant delivery flushes chips from the cutting zone while the double margins guide the drill for improved hole quality and alignment. This configuration reduces heat buildup and minimises the risk of wandering in deeper holes. The practical limit is the machine’s ability to supply adequate coolant pressure and flow through the tool holder. Without sufficient pressure, chip packing can still occur in difficult materials.
5/32 Diameter Application Range
The 5/32 inch diameter suits a range of small-hole drilling tasks in steel, stainless steel and exotic alloys where coolant access is critical. It comfortably handles production runs requiring tight tolerances and good surface finish. The drill reaches its limit in extremely deep holes beyond the flute length or in materials that demand specialised point geometries not featured on this model. Proposition 65 warnings apply for chemical content.
Highlights
- Coolant-fed design clears chips for deeper holes
- Double-margin construction improves hole straightness and finish
- 3× diameter reach extends drilling capability
- 5/32 inch diameter suits precise fastening tasks
- New M.A. Ford drill ready for immediate use
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How does the 3X coolant-fed design affect chip evacuation compared with a standard drill?
The triple coolant channels flush chips directly from the cutting zone, reducing heat buildup and preventing re-cutting of swarf in deep holes.
What practical limit does the 5/32 inch diameter place on hole depth in steel?
At 5/32 inch the 3X length-to-diameter ratio allows controlled drilling to roughly three diameters deep before pecking is normally required.
Which shank standard does the CXDCS1562AP use for tool-holder compatibility?
The drill uses a common straight shank that fits standard ER collets and Weldon holders without an adapter.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
