M.A. Ford
M.A. Ford Cyclone Xd 3X Coolant Fed Double Margin Drill 1/8
A 1/8-inch coolant-fed double-margin drill designed for efficient chip removal in deep-hole applications
- Coolant-fed design improves chip evacuation and tool life
- Double margin construction enhances hole accuracy and surface finish
- 3X diameter capability allows deeper drilling in fewer passes
- 1/8 inch diameter suits precision machining applications
- California Proposition 65 warning indicates chemical safety awareness
Cyclone Xd 3X Coolant Fed Drill
The M.A. Ford Cyclone Xd 3X is a coolant-fed double margin drill built for precise holemaking in demanding materials. Its 1/8 inch diameter suits close-tolerance work where straightness and finish matter. The tool arrives new and ships directly from the manufacturer.
Suited for high-precision drilling
Machinists running CNC cycles that require consistent chip evacuation and thermal control will benefit from the internal coolant channel and double margin design. Shops without through-spindle coolant capability or those needing larger diameters should look at alternative tooling.
1/8 inch cutting diameter
The 1250 series designation corresponds to a 1/8 inch drill diameter, the single dimension that determines fit for your programmed hole size. Verify this matches your drawing before ordering.
Highlights
- Coolant-fed design improves chip evacuation and tool life
- Double margin construction enhances hole accuracy and surface finish
- 3X diameter capability allows deeper drilling in fewer passes
- 1/8 inch diameter suits precision machining applications
- California Proposition 65 warning indicates chemical safety awareness
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What spindle size does the 1/8 inch drill shank require?
The drill has a 1/8 inch shank designed for standard collets or chucks that accept that diameter.
How do you connect coolant feed to the CXDCS1250AP through the tool holder?
Use a coolant-fed holder with an internal passage that aligns with the drill's through-coolant holes; ensure the holder seals at the shank so pressure reaches the cutting zone.
When should the double-margin drill be replaced based on corner wear?
Replace the drill when the margin lands show visible rounding or when hole size drifts beyond tolerance, typically after the carbide corners lose their sharp edge.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
