M.A. Ford
M.A. Ford Cyclone Drill for Aluminum 5X 2 Flute Coolant Fed CDACRM0680
Coolant-fed 5x-diameter drill with two flutes for efficient aluminum machining
- Designed for aluminum with 5× diameter reach
- Two-flute geometry clears chips efficiently in soft metal
- Coolant-fed design delivers fluid to the cutting zone
- M.A. Ford brand backs professional-grade cutting performance
- California Proposition 65 warning applies to this product
M.A. Ford Cyclone Drill for Aluminum
The M.A. Ford Cyclone Drill CDACRM0680 is a 5X diameter, 2 flute, coolant fed tool designed for aluminium machining. It targets machine shops and fabricators who need a dedicated drill for non-ferrous materials. The coolant fed design supports efficient chip evacuation during deep hole drilling operations. This new drill arrives ready for use in compatible tool holders.
5X Diameter Depth Constraint
The 5X diameter specification defines the practical drilling depth limit relative to the tool diameter. This ratio balances reach with rigidity for aluminium workpieces. Exceeding this depth increases deflection risk and reduces hole accuracy in soft materials. Coolant pressure and feed rates must match the 5X geometry to maintain performance.
Two Flute Capacity and Chip Load
Two flutes provide ample chip space for aluminium's long, stringy swarf at the 5X depth. The design handles standard production volumes in wrought and cast alloys without frequent pecking cycles. Coolant fed delivery extends tool life by reducing built-up edge formation. Very high speed machining or abrasive aluminium silicon alloys may exceed the flute capacity and wear resistance.
Highlights
- Designed for aluminum with 5× diameter reach
- Two-flute geometry clears chips efficiently in soft metal
- Coolant-fed design delivers fluid to the cutting zone
- M.A. Ford brand backs professional-grade cutting performance
- California Proposition 65 warning applies to this product
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Should I choose the CDACRM0680 or another Cyclone drill for my aluminium job?
The CDACRM0680 is the specific model listed; select it when your application calls for a 5X, two-flute, coolant-fed drill from M.A. Ford.
What does the 5X designation mean when the drill is in the machine?
5X indicates a length-to-diameter ratio of five, so the flute reaches five times the nominal diameter for deeper holes in aluminium.
How does the coolant-fed design affect the drilling standard I can achieve?
Internal coolant delivery evacuates chips and controls heat, letting the drill maintain tighter tolerances and longer tool life in aluminium.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
